Electronics Forum | Sat Dec 04 09:09:45 EST 2021 | hello112
Yamaha factory tools_p-tool_v1.72std_r1.000 Free sharing and communication
Electronics Forum | Thu Sep 08 18:10:09 EDT 2022 | mt396596
We just went through a similar issue with our MY12E. Make sure your Midas vacuum system is working, check your Midas Z friction. Also verify the Centering unit centering band. You can swap your MOTZ and MOTC to rule out the card. The tool install t
Electronics Forum | Mon Nov 26 14:48:43 EST 2001 | PeteC
The tooling fixture has tooling pins to accomidate your PCBs. Typical PCB tooling holes are 0.125" dia. non-plated thru holes and 0.250"x0.250" from the edge of the PCB. Check out this link to EMC Global Technologies. They mfg. tooling fixtures for U
Electronics Forum | Tue May 18 13:04:46 EDT 2004 | gregp
Partition the toolbox and label the partition with what tool belongs there. Place a clipboard alongside the toolbox with a signout sheet. Instruct the employees that EVERY tool removed from the box must be signed out and signed back in when returne
Electronics Forum | Thu Jun 03 14:12:25 EDT 2004 | russ
Thanks Rob, $7k, for a bag of silly putty with a magnet! This is supposed to be the same cost as tooling pins and much cheaper than dedicated tooling? I can't remember ever spending 7k on tooling unless I had 20 unique plates made. I wonder how ma
Electronics Forum | Mon Oct 21 09:41:42 EDT 2019 | mendezt6
Update: -The A12 tools will install in the 2nd machine. -Modified an A12 tool to install in the A13 tool location. -The modified tool will install in the A13 location of the 2nd machine, but not the 1st machine. Check that the parameters o
Electronics Forum | Mon Jan 06 16:58:45 EST 2020 | cbeneat
I would recommend quik-tool. Jim Bernhard essentally the inventor of Grid lok left when they went to DEK. Started quik-tool, we use grid-lok in our printers, quik-tool in our Panasonic P&P instead of support pins. Like quik-tool alot more. JBernhard@
Electronics Forum | Wed Aug 04 18:12:27 EDT 2021 | tomdegas
I am trying to install an A12 tool on my MY15 and I get the following error: "F-TLMN-9: Failed preliminary fetch during installation" I looked it up and it says Operator error and that the tool is missing. The tool is in the tray and the MY15 picks
Electronics Forum | Wed Mar 05 10:02:47 EST 2014 | dyoungquist
Per the TPSys Version 2.4 Software Manual: Force sensor level not within limits. * Force sensor dirty (inside Z tool holder) * Bad force sensor connection Try this: Remove the tool from the Z Midas head. Take a cotton tipped applicator (Q tip) and
Electronics Forum | Tue May 28 16:19:52 EDT 2002 | zanolli
Hello Floyd, Yes, special tooling is required. The tooling usually consists of a press, push-in tooling and support plate tooling. The presses can range from relatively simple arbor type presses to automated hydraulic presses with sophisticated con
