Electronics Forum | Mon Nov 08 18:05:18 EST 2004 | russ
Looks like we have been running the cure a little short (but only by about 44 min). I need to check if elevated temp shortens cure time to 1 min. at 700F! Thanks Dave, much appreciated Russ
Electronics Forum | Wed Jul 16 00:14:34 EDT 2008 | vms
We have been succesful in repairing some of them. If you would want to send it to us we would try to fix it. Would charge you if we was able to repair it. Harry 740-403-9406
Electronics Forum | Thu Jul 17 09:21:29 EDT 2008 | proy
What did the DC to DC power supply card have to do with it, and where was it in the system? Pete
Electronics Forum | Thu Sep 17 14:17:27 EDT 2009 | edmneb
I had a 4796a front CRT touchscreen controller crap out on me... Anyone know where I can find one or a current cross might be? Thanks!
Electronics Forum | Mon Sep 21 10:52:34 EDT 2009 | smtbox
Would you please post the part number of that controller and detailed picture you are looking for? We will try our best to assist you to resolve the problems.
Electronics Forum | Wed Sep 23 22:44:33 EDT 2009 | smtbox
We regret to inform you that we cannot find the source of this controller. But we stock various kinds of CT type feeder, please let us know when you are looking to purchase.
Electronics Forum | Mon Nov 08 15:10:52 EST 2004 | russ
We usually get some mask material from our board house. It cures with heat so it works really well in our applications. Be wary of the "overcoat pens" they don't seem to hold up under heat and thre solder will flow right underneath it during BGA a
Electronics Forum | Sat Jul 19 19:23:48 EDT 2008 | proy
We got it working; We replaced the old video card with an older ISA video card to get the display to work. Then we removed the ELO touchpanel ISA card, which cleared an IRQ conflict with the mouse on COM 1. Running mouse drivers AND VGASPM.EXE fro
Electronics Forum | Mon Sep 21 11:29:52 EDT 2009 | edmneb
The part we are looking for is the touchscreen controller manufactured by Microtouch. There is no specific part number called out in the UIC drawing book, but the part that we found on the PCB of the Microtouch unit was 7209401. We did swap the con
Electronics Forum | Tue Nov 09 10:44:13 EST 2004 | russ
I guess i might want to throw this in for future reference. After speaking with our board supplier he states that this mask is fully cured when it reaches approximately 180C. I beleive this since we usually probe the repaired area after putting the