Electronics Forum | Wed Oct 24 09:25:23 EDT 2018 | filipblad
The solenoids seem to work properly and there are no problems when initiating the Z-axis
Electronics Forum | Mon May 13 11:05:49 EDT 2013 | shankar2013
I have moved the MOT cards. The messages are still the same. Booster +25V is stable, The BM3 +25V indicator shows no +25V which means any of the feeds down the chain pulled it down. So basically once it is low the relays in the BM3 card will not latc
Electronics Forum | Tue May 07 16:19:47 EDT 2013 | dyoungquist
The "25v reads 3V" part of the error message may be your clue. Since the machine runs for a while and then shuts down, something may be failing after it warms up. "F-AXIS-182:C-AXIS NOT properly out when expected" refers to the centering jaws not o
Electronics Forum | Wed May 08 09:39:14 EDT 2013 | dyoungquist
Your centering jaws are likely okay. It's the 25V that runs the centering jaws that is having the problem. Could be the circuit that produces the 25V is having problems after warmup or maybe the motor that runs the centering jaws is going bad. Loo
Electronics Forum | Mon Oct 25 18:13:16 EDT 2010 | dyoungquist
When we bought our refurbished TP9 from Mydata in 2004 it came with a package library that contained all the common packages at that time. I am surprised that your MY12 did not come with at least that. Have you tried calling Mydata tech support dir
Electronics Forum | Wed Sep 30 06:25:14 EDT 2015 | strongbyte
I am looking to buy a Flexible magazine for a Mydata TP9-UFP I have seen both TMCFlex and TMDFlex magazines available, does anybody know the difference between the two and whether they are compatible with my machine. I spoke to a Mycronic engineer
Electronics Forum | Tue Jan 25 17:08:10 EST 2005 | Grant
Hi, I had one of those machines older MYDATA TP9 machines once, and it should work as well for very low volume applications, although the points you raise are correct. However you should get good accuracy on fine pitch, and we noticed you need to pu
Electronics Forum | Sat Dec 17 02:15:25 EST 2005 | manyhats
Fastek, i believe your right something manual or semi will work great... don't waste time or money buying that fully auto printer, they all do that same Sh&t... i have 2 TP-11 and think you should be ok placing the 0402 using the C14 tool and mechani
Electronics Forum | Tue May 07 13:51:51 EDT 2013 | shankar2013
acceleration is set to lowest. Ribbon cables were replaced, theta motor replaced. I also see a message pop up just after F-MOT1-26/156:MOVFI: MOTOR TIMEOUT / F-AXIS-182:C-AXIS NOT properly out when expected / 25v reads 3V. Now all these messages
Electronics Forum | Thu Oct 15 21:29:42 EDT 1998 | Scott McKee
| I need to install some new lines for high mix low volume products in an already cramp building. Could someone share any info about the machines which give you the best bang for floor space. I need a 2 machine system for placing 0402 to fine pitch,
.gif)
