Electronics Forum: troubleshooting (Page 2 of 41)

Components Sticky troubleshooting

Electronics Forum | Thu Dec 12 21:38:02 EST 2019 | peterhuang

Does anyone encounter components sticky problems? I think it should be ESD problem in cover tape.

Components Sticky troubleshooting

Electronics Forum | Sun Dec 22 21:56:17 EST 2019 | sssamw

yes, contamination could cause sticky also.

Components Sticky troubleshooting

Electronics Forum | Mon May 18 02:23:57 EDT 2020 | peterhuang

We can use cover tape to solve, SMT throwing rate can be reduced to less than 3%.

Fuji CP troubleshooting

Electronics Forum | Wed Jan 05 10:22:55 EST 2005 | Mike B

We're getting an error on our CP643 that we can't seem to make sense of. It's a D1 axis error, but we're only getting it when we run a feeder on device 140. Any advice would be appreciated.

Fuji CP troubleshooting

Electronics Forum | Tue Jan 11 12:43:17 EST 2005 | ricardof

I guess it will be the size of the feeder on that position (Perhaps you're using a 12x8 or 16x8)

Fuji CP troubleshooting

Electronics Forum | Mon Jan 17 15:34:38 EST 2005 | montec2000

Just a thought, but check to make sure you dont have a pickup offset in your pd or machine thats causeing your problem.

troubleshooting simplematic board loader

Electronics Forum | Wed Oct 13 12:19:52 EDT 2010 | markhoch

It might be half that. I can't remember. I'm an old man and I'm frazzeled!

Components Sticky troubleshooting

Electronics Forum | Fri Dec 20 10:00:37 EST 2019 | sangbui

Hello, We have the same problem as you. We have used Acetone to remove sticky successful. Thank you

troubleshooting simplematic board loader

Electronics Forum | Thu Oct 07 15:17:57 EDT 2010 | debron1

I am trying to repair two Simplematic 8130 board loaders. I have the same error on both of them. The error says " NO PLC Loaded." I don't believe that it is the plc but instead the display "uticor" system. Can anyone give some advise on how to fix th

troubleshooting simplematic board loader

Electronics Forum | Mon Oct 11 17:14:30 EDT 2010 | markhoch

I've had this problem before. Typically happens when the Lithium Battery dies and the machine loses the program. Usually you can pull the displays out and ship them to Simplematic. They can reload the program for you. Roughly $2500 bucks I think. Cal


troubleshooting searches for Companies, Equipment, Machines, Suppliers & Information