Electronics Forum | Thu Nov 11 15:12:29 EST 1999 | Jamie Marsh
I found a lot of information about UniCam at their web site. Check it out. http://www.unicam.com
Electronics Forum | Mon Aug 03 12:33:19 EDT 1998 | Dew Lolly
I and I imagine most of you, are embroiled in the turf war going on between CIMBridge and Unicam. Since Fuji is squarely in the center of this issue I would imagine that many of you are wondering which way to lean. I'm wondering if we are not going
Electronics Forum | Tue Aug 04 10:04:08 EDT 1998 | Wayne
Dew: Is this the third or forth software alignment for Fuji? Hope they stick with Unicam for a period of time... Just my two cents....
Electronics Forum | Tue Jun 18 13:22:53 EDT 2002 | gwaco
Hello all, I support the floor issues and it seems that a vast majority of our connecters always place off in the x or y. We are using IP3's with unicam software. Has anyone else run into this and what was the fix. Thanks Greg
Electronics Forum | Wed Jul 03 11:54:15 EDT 2002 | Jim
I am using the Fuji MCS computer and need to upgrade due to hard drive space limitations. Does anyone have any positive or negative feedback with using FujiCam or UniCam?
Electronics Forum | Fri Feb 10 08:47:45 EST 2006 | davef
Centroids from the Gerber data * Graphicode GC-Place graphicode.com * Downstream Technologies CAM350 downstreamtech.com * Gerbcam Tecnomatix-Unicam unicam.com * Circuit Cam aiscorp.com * GerbTool GerbTool.com
Electronics Forum | Tue Apr 18 16:30:17 EDT 2006 | ratsalad
At my previous employer we ran HSP - GSM lines. Some sites used CIMBridge, others Unicam. We all used UCT52, not USOS, for the HSPs. At that time we had 4796's, 4791's, and USOS 4.X on our GSMs.
Electronics Forum | Mon Aug 31 10:28:11 EDT 1998 | Patrick O'Connor
| | | | Dew: | | | Is this the third or forth software alignment for Fuji? Hope they stick with Unicam for a period of time... | | | Just my two cents.... | | I believe it's the forth, MCS OS/9, MCXE,F4G, and now fujicam...were there any others I m
Electronics Forum | Fri Jan 12 19:25:29 EST 2001 | Brian W
Fabmaster is Unicam is Tecnomatix now. Tecnomatix bought both Unicam and Fabmaster in the past couple of years. Their software is good. You can also try Cimbridge from GENRAD, CircuitCam. Valor has a very good DFM module. Each one has pros and c
Electronics Forum | Fri Mar 22 19:20:19 EST 2002 | mcox
This is the same misinformation half-truth BS I have been hearing from CircuitCam for a long time. The truth is, Unicam has a product that automatically recognizes the Component and Ref designator, where CC requires the user to input each and every