Electronics Forum | Thu Jul 21 02:45:51 EDT 2005 | Base
Probably very far-fetched, but I can think of a scenario like this: - machine picks up a component - between vision and placement the part is lost, but the loss is not detected due to oversize tool, which causes the amount of vacuum drop to go unnot
Electronics Forum | Tue Aug 29 08:11:12 EDT 2006 | davef
"... we've coerced Josh into driving us out to Watson's bay, braving the horrendous parking situation, to visit Doyle's." Good for you, but you could be parking on a sinkhole: http://www.uwsp.edu/geo/faculty/ozsvath/images/winter_park_sinkhole.htm
Electronics Forum | Thu Feb 07 13:46:07 EST 2008 | slthomas
I would probably try to get my boss to spring for a digital anemometer (air velocity meter) and figure out what my velocity needed to be to get the specified airflow. Then just check it daily before production starts and when it starts to slow down,
Electronics Forum | Fri Nov 30 18:27:32 EST 2007 | jmelson
This doesn't help the original poster any, but does the Quad have any sensing of what is going on in the feeder? On the pneumatic or mechanical Philips feeders, if the tape jams in the feeder for some reason, the head just keeps tapping the lever an
Electronics Forum | Wed Sep 04 13:58:36 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the response. 1. Function 30 gives me a consistent 182-185, even after nozzle changes. I can vary this by changing mod code 15 and I have been advised to aim for 90-110, but it doesn't seem to make any difference so I've go
Electronics Forum | Tue Apr 01 09:58:52 EST 2003 | davef
You're entirely correct. The gold is most likely gone away. [Don't forget you can check if the surface is still solderable with a hand soldering iron.] We're not sure it it will give you the results you seek, but consider using a dye penetrant fai
Electronics Forum | Fri Jul 20 07:09:29 EDT 2007 | chrispy1963
Sr. Tech, youre absolutely correct that the X-Wagon (pancake) motor is the one which will do final positioning when moving to a programmed position. The X Axis motor in back of the machine is used for rapid traverse of the axis. I was thinking more
Electronics Forum | Wed Sep 04 09:47:41 EDT 2019 | smrsteve
Hello All, I've just bought a Quad 4c pick & place machine. It's so close to actually building boards, but just doesn't quite get there. I was wondering if there's somebody out there with experience of these machines that might be able to help...?
Electronics Forum | Fri Jun 11 04:38:05 EDT 1999 | Gyver
| | | | | Hello all! | | | | | Recently we got a problem about the Funtional test. Some boards passed tests by using the auto-fixture(vacuum), but failed by using manual test fixture(need to plug CPU, DIMM etc.). The error symptom is no picture. We d
Electronics Forum | Thu Jun 28 20:11:32 EDT 2007 | rfrog
Hi folks, I've been bouncing off of MyData technical support for some time on an issue with a MyData machine. Seems that this My9 likes to skip an 0402 placement at a rate of ~ 1000/million. Profile: MyData My9 Mechanical centering Midas only
.gif)
