Electronics Forum | Tue Mar 03 02:39:56 EST 2015 | sarason
I would presume you reflow the top of the board first. Use tented vias. As you have worked out, vias have surface tension, which sucks the solder up the hole during reflow of the bottom of the board. Good luck! regards sarason
Electronics Forum | Mon Mar 02 23:48:22 EST 2015 | vb7007
Hi We are using Universal carrier for a 2 sided PCB, where the bottom side goes for hand solder the switches after wave. Our issue is, we are getting micro solder balls all over PCB bottom after wave, whereas we got numerous vias, which also turns
Electronics Forum | Tue Mar 03 09:29:48 EST 2015 | rgduval
A couple of things that have helped me with solder ball issues at wave in the past: 1. Flux. Insure good flux coverage on the bottom of the board. 2. Preheat. Insure that the board is sufficiently preheated for the wave operation. Since you're