Electronics Forum | Sat Mar 03 09:51:17 EST 2001 | PeteC
Wow! Nope, wouldn't wanna see it and hope I never do. Our 7.4 RS quake (that lasted for 45 seconds!) August of 1999 in Istanbul happened at 3AM and the plant was closed. We ran production that day starting at 7:30AM. Only 2 people failed to show up
Electronics Forum | Tue Sep 02 13:35:29 EDT 2008 | evtimov
Hi, I don;t thing there is an overtemperrature sensor. Just the thermocpouple returns a higher temp(voltage) to the controller and your software goes to alarm, cooldown or what ever it does. Emil
Electronics Forum | Thu Sep 04 02:43:09 EDT 2008 | benefon
Thanks This error only occurred with one oven profile with the reflow zone temperature set at 270�C. Perhaps it really has to do with the exhaust pull as the oven is operating very near its temperature limit with this profile. I will check that. Tha
Electronics Forum | Mon Sep 01 04:55:20 EDT 2008 | benefon
Hello all Our Omni 5 has given the 'Cooling module high temp' warning twice during the past month. I suspect that the blower motor is the culprit but have not been able to verify this because the oven has started up normally after acknowledging the
Electronics Forum | Wed Sep 03 07:39:19 EDT 2008 | pjc
You may not be getting enough exhaust pull, so the cooling modules over temp. Try swapping blower motors to isolate that before buying one. STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unlo
Electronics Forum | Thu Oct 20 10:29:45 EDT 2011 | babe7362000
Can anyone tell me what a Tactile 12-Hardware Limit Warning is on the MPM Up2500? I tried to reset the machine and it gets stuck on the Tactile. If anyone can help, I would appreciate it. Thanks
Electronics Forum | Wed Dec 20 10:04:07 EST 2017 | junkeymonkey246
Hello there, I work at Redcom Laboratories in Victor NY. I'm a student and new to being a machine repair technician. I'm having some bother with one of our TYCO QUAD QSP-2 machines. I keep getting the errors: "WARNING: Head#2 Nozzle RUNOUT=27.1 mi
Electronics Forum | Tue May 26 23:42:20 EDT 2020 | smiran082
Hello, I am having trouble the QSV-1 PNP machine. On boot it had trouble connecting to the RT computer as it was hung on a message saying something along the lines of, "Establishing connection to RT computer". After several restarts we still could
Electronics Forum | Tue Nov 01 18:33:10 EDT 2022 | griinder
I assume you are programming with DPO? I am using a Fuzion, so it may be a bit different. In "Environment Settings" (The little PC icon in the DPO start bar) under the products tab I am able to change the product load options to "warning" instead of
Electronics Forum | Fri Sep 24 06:17:47 EDT 2010 | bullyparade
Hi all, we use a MPM UP2000/B printer and facing the following problem: During startup/initialisation process the printer stops after a while and comes up with the following alarm "hardware limit warning". This can be repeated several times with the