Electronics Forum | Thu Oct 28 03:52:19 EDT 1999 | Ron Lahat
Looking for low cost First Article workstation for PCBAs ? The environment is low Volume High Mix PCBA production There is a constant need to do firs article in all three shifts (24 hours) Currently it is not automated, it is time consuming and op
Electronics Forum | Mon Aug 19 15:42:27 EDT 2002 | loquetis
Is there any significant difference in the time required (average) to reflow a BGA component versus replacing the component? My company is attempting to determine the time to break-even for capital investment in a BGA workstation.
Electronics Forum | Wed Jul 14 20:13:33 EDT 2004 | engineerx
Hi, I've been evaluting a few AOI for my company including Cyberoptic. Of those, Orbotech do provide workstation for verification purpose.Some AOI inspection time might vary with the size of the board.
Electronics Forum | Tue Jan 23 20:42:08 EST 2007 | thunderdog5000
I have recently purchased a barco aoi unit. Does anyone know how to convert the data from a CAM350 workstation into useable information on an Barco accumatch aoi
Electronics Forum | Tue Jul 01 17:42:18 EDT 2008 | dilogic
Can't be done. HP300 are Motorola MC68K-family based UNIX workstations and you can't run machine software on PC-based hardware. - Deni
Electronics Forum | Thu Jun 01 08:54:46 EDT 2000 | Chris May
Dear Ashok, My practice is that if you see it as a source of a potential problem, label and monitor/measure/test it. OK, so it may be a lot of work up-front, but what is the risk involved in not doing it ?? There is no grey area, do all or nothing
Electronics Forum | Thu Jun 01 08:54:50 EDT 2000 | Chris May
Dear Ashok, My practice is that if you see it as a source of a potential problem, label and monitor/measure/test it. OK, so it may be a lot of work up-front, but what is the risk involved in not doing it ?? There is no grey area, do all or nothing
Electronics Forum | Wed Jan 27 10:03:39 EST 2016 | mjscottinnc
Through trail and error we figured that out the Ethernet connections from the MC to SC. We have gotten past the Software booting wait and are now waiting to connect to Siplace Pro. The machine came with no documentation other then what the service te
Electronics Forum | Tue May 23 16:56:10 EDT 2000 | Ashok Dhawan
For grounding Table Mats/ Floor Mats and workstations, does grounding resistor need special characterstics e.g Wattage, material of construction, etc. We intend to use 1M Ohms resistor. EIA-625 does refer to EOS/ESD-S6.1 standard ( paragraph 7) fo
Electronics Forum | Wed May 02 16:20:01 EDT 2001 | mparker
As a second thought, just to address your problem, try contacting a local fabrication shop for restaurant supply. They are used to working with stainless steel. I once had a complete sink/workstation top fabricated to my specs. for a fraction of the