Electronics Forum | Thu Aug 02 14:10:55 EDT 2018 | jdengler
Could they be on the wrong axis from what they are configured for (X and Y swapped)? Jerry
Electronics Forum | Thu Aug 02 09:14:17 EDT 2018 | jeffallen662
Hey I'm having some issues with a YesTech YTV-1000 AOI machine. The machine isn't recognizing the X and the Y stepper motors. As far as we can tell nothing mechanical is wrong with the AOI. They are new motors and were suppose to have been programmed
Electronics Forum | Fri Jun 17 17:11:59 EDT 2005 | stansmt
I have been working with the Yestech system in my facility after evaluating the Mirtec. The yestech system has far less false calls and better defect coverage based on the test vehicles I ran. The YTV-1000 out performed the Mirtec in defect detection
Electronics Forum | Sat Jul 30 21:47:26 EDT 2011 | garym4569
We just installed a YTV2000 and are having issues with the conveyor SMEMA. YesTech tech support seems eager to help, but we have not found a solution. You may give them a call. If your AOI has internet access and depending on the model, tech suppo
Electronics Forum | Fri Apr 11 14:05:28 EDT 2008 | devgru
We use our YESTech YTV-F1 for our 2D solder paste inspection and it works very good for us.
Electronics Forum | Fri Nov 07 23:12:14 EST 2008 | edmaya33
We are little bit interested with the Yestech YTV-F1 series machine. We are using Landrex AOI eversince ( formerly Teradyne ), the OPTIMA II-7301. How about the price? the OPTIMA-II cost about $97K including the repair station.
Electronics Forum | Thu Apr 19 18:03:56 EDT 2018 | spikesnpearls
hello i am a new aoi programmer and i was wondering how to choose/change what type of lighting it uses while scanning the board.i use a yestech ytv-fx
Electronics Forum | Thu Aug 27 10:22:59 EDT 2009 | dwl
We have an opportunity to purchase a Yestech YTV-1000 AOI machine. I am looking for opinions on how well they work and how they compare to the newer Yestech B3 AOI systems. We are a high mix, low volume EMS company. We do not currently have any exp
Electronics Forum | Mon Apr 05 09:33:42 EDT 2010 | flanz
Hello. I'm new to the group and would like to ask a question about a YTV-2000 that I have. Question is - Could someone explain why my Yestech 2000 has a hardtime with calibration? What happens is that I run calibration before I start a new board.
Electronics Forum | Fri Jul 22 18:22:36 EDT 2011 | garym4569
We have a inline YesTech YTV-2000 in a newly configured SMT line and having issues with the transfer system. Shortly after the unit is put in run mode, the conveyor will turn on and run as if it is attempting to load a pcb even though no pcb availab
