Electronics Forum: check (Page 12 of 597)

CP6 Nozzle sticking

Electronics Forum | Wed Feb 16 09:44:09 EST 2005 | beta

Check to see if its the same component everytime if so check part height . Also check Z0.This setup is in the manual. You say this only happens after maintenance is carried out so when you free the nozzle it doesnt happen again until maintenance is

Reflow soldering of 208-RQFP-0.5mm

Electronics Forum | Mon Oct 31 08:29:51 EST 2005 | chunks

Shifting? Please describe the "Shifting". I.E. is it centering, sliding to cause shorts..... Most 208s will self center. If it's causing shorts, first check your print to make sure it is on the pads. Next check placement. Another area to check

lead free selective soldering

Electronics Forum | Thu Nov 03 09:43:55 EST 2005 | lupo

Check flux penetration and type of flux. How much is solid contents. The solder filling is better under Nitrogen. Check the time (speed) of the nozzle whether is correct. Usually For SAC305 the temperature of bath is 320C/degrees, but only for sel

cem audit check-list

Electronics Forum | Thu Jun 29 04:22:12 EDT 2006 | Olas

Hi, Can anyone provide a check-list to evaluate the capability of a subcontractor for assembling boards? I mean a list of items to check like number of SMT production lines, kind of machines (screen-printer, pick-and-place, oven, AOI, etc.), throug

CP642

Electronics Forum | Thu Jul 20 12:05:44 EDT 2006 | vikkaraja

Hi there to all, I have noticed one of my cp is making very loud thumping sound from the table lately. This noise is only from X-axis not the Y at all. Here are the following things that I went through so far: checked if this was due to lack of lub

Old Solder Paste reclamation service????

Electronics Forum | Fri Mar 02 10:00:11 EST 2007 | jseagle

Check out ECS refining, they will recycle your paste and dross and cut you a check. We usually send 1 55 gal drum of dross and 1 55 gallon of waste and get a check back for ~$150. You can also contact the solder suppliers they usually have recycle

3D xray

Electronics Forum | Thu May 31 11:07:23 EDT 2007 | pjc

ICT and AXI are two different methods for MDA. ICT checks component values and polarity- component and circuit electrical testing while AXI checks solder joints- volume, voids, bridging, etc.... Typically, AXI is in the SMT process engineering and QA

Checking your reflow ovens ?

Electronics Forum | Mon Oct 08 07:19:56 EDT 2007 | cyber_wolf

Is it common to check your reflow ovens proper operation with a separate system ? We check our ovens weekly with a DataPaq Surveyor. In 10 or so years of Data collection, I have never witnessed this weekly test prove anything of significance. I mea

Fuji CP6 Y-axis placement problem

Electronics Forum | Mon Mar 24 22:46:53 EDT 2008 | crashoveride

Don't try the mecha check yet unless you know how. have you checked the coupling shaft of Y-axis? If it's ok, take a look at the ball screw if it looks like being scratched or something unusual. Also, observe the movement of the machine if you hear a

QUAD 4C T axis

Electronics Forum | Thu Jul 31 07:28:04 EDT 2008 | leemeyer

This sounds like a Quadalign problem. Upon startup the Quadalign system checks runout of the Z-rod and tries to find the tip of the nozzle. It will keep lowering the Z-rod and looking for the tip until it hits it's limit. Check and see if the Quadali


check searches for Companies, Equipment, Machines, Suppliers & Information