Electronics Forum | Thu Nov 10 00:38:54 EST 2011 | tpappano
Hi Jeff, no problem, I'll just pop them out and make copies. I'm betting the upgrade will take care of these silly problems. The machine with the "newer" firmware just goes and goes without any issues other than replacing that R-axis servo a while
Electronics Forum | Sun Nov 06 19:20:23 EST 2011 | jeffr
Tom, Does this only happen on one job or all jobs ? If this happens again..you should clear the RAM memory, but changing the 10 year 3v lithium battery on the motherboard should also be considered at the same time. RAM CLEAR PROCEDURE: Power off, rem
Electronics Forum | Wed Nov 09 23:02:34 EST 2011 | jeffr
Tom, I cannot find the software to operate my Sunshine EPROM burner right now. It is safe for you to read out the files on each of the ROMs using your burner. It is just a plug in, plug out operation to get the machine going again. The machine will s
Electronics Forum | Mon Nov 14 00:13:55 EST 2011 | tpappano
Hi Jeff, I pulled the proms from both machines, copied to disk, re-burned the the old versions with the newer and reinstalled. The ram became scrambled in the upgraded unit on startup, but I did a full restore through the serial port and unit #2 got
Electronics Forum | Mon Aug 05 09:16:39 EDT 2013 | valeriusx
Greetings. I'm having some difficulties in configuring 2 old SIPLACE Placement Machines - 80S-15 and 80F-3. They are already installed, there are no errors on machines computers, but I can't configure connection between these machines and the line c
Electronics Forum | Sun Jun 08 16:31:02 EDT 2014 | ipdisplays
Prob totally screwed the pooch... Got more than a little frustrated with not being able to get the stupid software to do what I thought it should do, anyway figured maybe the IEC port was the problem - I have a couple of spare cpu cards, so I swapped
Electronics Forum | Wed Nov 28 06:16:06 EST 2018 | mnyut
You need to look at what other smaller companies > are using, the KY machines usually go in > multiples into large installations. That's absolutely right, that the machines work excellently if they are only used for testing. But this also applies mo
Electronics Forum | Tue May 26 10:52:02 EDT 2020 | spoiltforchoice
No idea, could be a weird translation error, but its certainly something I have seen . For an FLX they just ask for this "5-6 bar, clean, dry, oil free, filtered 2 µm, connection diameter 8 mm", 40litre/min Personally I would go with a mo
Electronics Forum | Thu Mar 18 19:53:29 EDT 2021 | lhd_qa
Hello everyone. I am new to the forum so I am sorry if this has been asked before. Does anyone have any suggestions for counting partial reels and cut tape? We are a distributor and for our ecommerce PDC we keep having quantity issues. Currently, we
Electronics Forum | Fri Oct 28 02:18:03 EDT 2022 | kamedatec
I bought a YV100XG machine with AutoTC (Automatic Tray Feeder), Everything is working except AutoTC, when I active this function, pops up the error that the Servo Motor LZ1 was not found. I changed the control card of the servo motor, checked the wir