Electronics Forum | Wed Aug 10 12:05:11 EDT 2005 | Rob
Hi Pr, No idea what the material is - we haven't usd it for a while now, but it was flush & didn't cause any printing problems on double sided reflow. Your board house should know all about it - I would suggest some but ours are all UK or China/Tai
Electronics Forum | Thu Jun 05 16:44:19 EDT 2003 | blnorman
The data we have is from an IBM report. Below 100�C the SAC reliability is almost double that of SnPb (-40 to 100�C thermal cycle). When the upper end temp is increased to 125�C the reliability drops to 75% of SnPb. I'd like to see the data that s
Electronics Forum | Tue Aug 09 22:03:38 EDT 2005 | davef
Since these are mounting holes, they're probably all the same size. Why not try rubber plugs shaped like golf tees? Try: * Dempsey Industries; 802 N. 4th St, Miamisburg, Ohio 45342; (937)-866-2345; Gary Pascoe * Shercon somewhere in CA * Harman; 36
Electronics Forum | Thu May 29 17:48:00 EDT 2003 | jonfox
As far as I know, the limitations apply to to the manufacturing components, not the equipment per say. At this point there is no set date for the US at the national level. Basically our government is run by big businesses and their effect on our na
Electronics Forum | Tue Jul 27 13:48:45 EDT 2004 | Ralf
Hi Recently i have noticed that after reflow (hot air oven) on the solder lands without components but with solder(screen printing) there is discoloration. It looks like gasolin spilled on the wet road (rainbow). Any idea and reason Ralf
Electronics Forum | Tue Jan 31 14:23:39 EST 2006 | samir
Chunks, For our lead-free eval, we had the same problem with "charred looking" solder paste up the component termination of one of the smaller discretes, coupled with excessive solder balling...this smaller part did see peak temps in the 240 range -
Electronics Forum | Thu Mar 10 10:06:08 EST 2005 | steve
OK all you Gurus here's one for ya. Customer is tinning wires with standard eutectic solder in a solder pot. There is a blue tint to the solder in the pot. After tinning with OA flux, which I will change to NC shortly, he has clear teflon insulation
Electronics Forum | Thu Sep 23 08:08:12 EDT 2021 | SN
Hi. Anyone in this forum experienced the lead-free solder paste SAC305 and SAC405? What are the differences to expect for solder paste with SAC305 and SAC405? What is the effect of silver (Ag) alloy in solder paste? It was really appreciated if could
Electronics Forum | Wed Nov 29 11:46:57 EST 2006 | slthomas
IPC 610 *C* states that the solder thickness requirement is a properly wetted termination is evident. Fillet height is another aspect and is usually specific to the package but is some function of solder thickness plus a percentage of lead height. D
Electronics Forum | Thu Nov 30 15:19:56 EST 2006 | CK the Flip
Mike, dude, I feel your pain. Hearing stories like this makes my blood boil! It's almost as ridiculous as a customer who told me to put more solder paste on a MELF component to overcome noise issues - he used more solder paste as antennas to overco