Electronics Forum | Wed Dec 09 08:45:31 EST 2009 | orlando
Does anybody run conformal coating process using UV cure varnish? We have a long experience on solvented urethane coating material but switching to solventless is unknown for us. Could you recommand vendors for UV curing oven? Thanks
Electronics Forum | Thu Jul 07 11:35:16 EDT 2011 | blnorman
I had read somewhere that parylene absorbs UV radiation, and therefore offers very low UV protection. So, yeah probably not a good idea. Plus since it's vapor deposited, unless there is no access to a surface, all surfaces are covered.
Electronics Forum | Thu Jun 05 07:54:20 EDT 2008 | davef
You're correct, uV costs 1.7X solvent-based silicone. This high purchased material cost is counter balanced by uV requiring lower thickness due to higher solids and that 60 to 80% of a solvent coating is volitile and goes up the pipe between applicat
Electronics Forum | Thu Mar 31 10:14:06 EST 2005 | davef
There's some nice low-VOC uV coatings out there. We don�t use uV cured coatings, but try: * http://www.emersoncuming.com * http://www.dymax.com * http://www.mgchemicals.com * http://www.loctite.com * http://www.humiseal.com Be aware that uV co
Electronics Forum | Thu Jun 05 05:27:13 EDT 2008 | andy1975
Hi, I've been looking into UV cureable conformal coating and the UV ovens but a chemist I know is very negative about this. He suggest by heating standard conformal coating to 90deg for a couple of minutes will make the product good enough to handle
Electronics Forum | Fri Feb 21 02:00:53 EST 2003 | successmani
Hi, I would like to know how Conductive adhesives and UV cure adhesives are dispensed. I know that nonconductive adhesives are dispensed through jetter, Auguer pump annd other contact type method. I am puzzled and curious to know whether there is any
Electronics Forum | Wed Dec 02 00:31:37 EST 2009 | jlawson
UV40 for you info was developed in Humiseal EU and has been tested heavily against Dymax product. UV40 is a great product has many approvals from major auto and whitegoods makers.... I have seen comparisons UV40 to Dymax 984LV and Dymax comes out se
Electronics Forum | Fri Oct 06 05:56:37 EDT 2000 | Alberto Silva
Hi, Instead of using High Temp solder, I would like to use a UV epoxy to atach termocouples to reflow profile boards. Does any one know a good one? Thanks in advance. Alberto
Electronics Forum | Mon Feb 26 08:39:09 EST 2001 | Cal
Previously posted, was information regarding "BLUE DOT" UV inspection. The link for original solutions was incorrect. This is a process where a UV signature is imbedded at the board level to visually check missing components, tombstoning and polarity
Electronics Forum | Mon Apr 12 12:27:26 EDT 2004 | jseagle
Looking for manufacturers of UV Curing Ovens. Also, can you give me a ballpark price for one? Thanks James