Electronics Forum | Tue Apr 18 07:28:32 EDT 2006 | JH
Mark, I am having difficulty picturing exactly what you are doing, but I hope this helps. We occasionally use jigs through SMT, usually because the board is too small/thin to fit the smallest rail width. In such situations, we normally make the jig
Electronics Forum | Thu Nov 29 12:28:32 EST 2018 | slthomas
What I'm thinking is that your cutter/former (or whatever the "boot" shaped assembly is called, that provides the dies for cutting and forming parts from the tape) could be worn, dull, bent, etc., and once in a while you get a lead that doesn't enter
Electronics Forum | Tue Jun 27 05:28:32 EDT 2023 | ttheis
We powered up our Advantis machine after leaving off for several months. When we powered it up went to zero it we get an error on the y1 axis during zeroing. Command move home: pattern step 0. The y negative limit is hit during homing, the axis then
Electronics Forum | Wed Jun 17 17:09:36 EDT 1998 | Gary Rojo
| I am involved in the purchasing decision (Technical side) of which placement machine to buy. One of the criteria we need to specify is how many feeders, and what sizes. I have a provitional parts list of a job that we are most likly going to build.
Electronics Forum | Wed Jun 17 08:28:51 EDT 1998 | Steve Schrader
| I am involved in the purchasing decision (Technical side) of which placement machine to buy. One of the criteria we need to specify is how many feeders, and what sizes. I have a provitional parts list of a job that we are most likly going to build.
Electronics Forum | Tue Oct 05 06:28:32 EDT 1999 | Wayne S.
|hello morris type in quoting smt in archives and you will get some good insight. i had the same question at one time. wayne I am working on trying to define a cost per placement measure in our SMT assembly operations. | | Does anyone know where
Electronics Forum | Wed Nov 28 01:28:32 EST 2007 | shy
Q1:What is the relation between component standoff and drop missing? A1:component standoff will identify either solder paste at SMT side can form the fillet at component terminal or not. Drop/missing component is totally out of the topics since i jus
Electronics Forum | Fri Jun 19 02:02:01 EDT 1998 | Scott McKee
| I am involved in the purchasing decision (Technical side) of which placement machine to buy. One of the criteria we need to specify is how many feeders, and what sizes. I have a provitional parts list of a job that we are most likly going to build.
Electronics Forum | Wed Jan 20 07:28:32 EST 1999 | Wayne Bracy
Cunli: Knowledge of upcoming shows is interesting to all of us. Including the major papers that will be presented, Vendors exhibiting, what to expect to see at the particular show, and website locations for vendors and show would be helpful. 1. Wh