Electronics Forum | Thu Jul 31 15:41:23 EDT 2003 | davef
Q: Could any of you guys tell me what exactly is this greenish thing ? A: No, but is not copper oxide. Copper oxide is brown, the color of a penny [here in the US] or an untreated copper laminated trace on a board. Many copper salts are greenish in
Electronics Forum | Wed May 08 23:48:01 EDT 2002 | ianchan
Hi mates, someone told us to use mild HCL acid 5% to 10% solution and submerge the LCC parts into this solution. hopefully this will clean off the varient copper oxide layer on the LCC leadless terminal wall. after the HCL soak, submerge the parts
Electronics Forum | Thu Jan 25 04:55:08 EST 2007 | greg york
Strange as we have had huge problems with Silver in Many different Assembly houses. Mainly with Nitric Acid based Silvers causing blow holes, non wetting and even the Nitric etching away the tracks on fine boards. It has been one of the main problem
Electronics Forum | Mon Feb 25 21:13:12 EST 2002 | davef
No, none of us can tell you what is the acceptable level of halide content or contamination in flux residue. The level of harmful residues on your product helps determine the reliability of your product. We know nothing of your product, its custome
Electronics Forum | Sun Jun 27 06:27:15 EDT 1999 | Vic Lau
| I am looking for a way to clean solder off of QFP packages. I'm thinking a chemical method would be easy, as long as the chemistry doesn't attack the leads themselves, or the package. | Any suggestions? | Dear Matt, I have a customer, who is com
Electronics Forum | Mon Jun 28 14:36:34 EDT 1999 | John Thorup
| | I am looking for a way to clean solder off of QFP packages. I'm thinking a chemical method would be easy, as long as the chemistry doesn't attack the leads themselves, or the package. | | Any suggestions? | | | Dear Matt, | | I have a customer
Electronics Forum | Mon Apr 13 12:06:53 EDT 2009 | jefflkupkt
BoardHouse, Thanks for the reply. The board supplier did cover the cost of the bare boards. Five years ago I saw a different part pass ET only to fail at final assembly test as well. One engineer called it "acid trap" on the inner layers where the
Electronics Forum | Fri Jul 10 07:34:00 EDT 2020 | elijah
From the poor bonding strength of the board, the surface quality problems of the board are divided into: 1. The cleanliness of the board surface; 2. The problem of micro graphite (or surface energy) on the surface. PCB circuit board proofing Youke bo
Electronics Forum | Fri Oct 28 04:56:12 EDT 2016 | lilybell
I read a few posts here about resistor in led applications. The thing is, the resistor has clarified as this shows:was always use with a power source delivering a higher forward voltage than the led could tolerate(ex: a 9volt battery hook up to a 3w
Electronics Forum | Wed Dec 12 07:38:04 EST 2001 | smtspecialist
I have observed the same thing with solder composition in this case I am using 63/37 NC which is giving good results usualy. The liquid tin, product from MG Chemical that I used is to tinplates copper circuit on PC boards. I tried on few relays, it
