Electronics Forum | Wed Aug 05 06:34:33 EDT 2020 | oxygensmd
Yes if you adjust the thickness to be thin than the machine raise the PCB more to the stencil - than the foil have better tension but it string out faster.
Electronics Forum | Wed Jul 05 14:55:53 EDT 2023 | robertobsuinc
How can I adjust the stencil frame size on my MPM speedline accela? is there an automatic option or I need to do it manually?
Electronics Forum | Wed Aug 05 08:57:23 EDT 2020 | oxygensmd
Snap off is an option to make distance between PCB and stencil. If the distance not enought, adjust the PCB thickness too. Mostly we don't use snap off, I more prefer if the stencil is tight with the PCB - I know, this make the stencil lifetime worst
Electronics Forum | Thu Jul 06 12:23:43 EDT 2023 | poly
On my one and I think all of them you need to do it manually. Send the stencil shuttle to front, There's two hex screws either side (4 total) you need to loosen. There a little indicator for the different common sizes. Then send the shuttle to the
Electronics Forum | Tue Aug 04 04:20:36 EDT 2020 | bangir
Hi Chris, It's arround +/- 2MM. There was a gap if running pcb with thickness 1MM. The PCB position below the rail table.
Electronics Forum | Tue Aug 04 22:26:38 EDT 2020 | cbeneat
So 1MM is the board thickness in your program?
Electronics Forum | Wed Aug 05 07:38:17 EDT 2020 | bangir
Hi Cris, Yes, The PCB thickness is 1mm. the PCB position below the rail thickness when the table go up the print position. Please advice or do you the service manual book.
Electronics Forum | Thu Aug 06 22:37:45 EDT 2020 | cbeneat
Try 2211. I honestly can't remember what this gets you into. But I used it years ago.
Electronics Forum | Sat Aug 08 06:43:17 EDT 2020 | oxygensmd
9060, service code 3560, engineer code (as I remember)
Electronics Forum | Thu Aug 13 19:23:06 EDT 2020 | kojotssss
Call +4 (Christian) Ekra screen printer specialist.