Electronics Forum | Fri Jan 04 14:42:20 EST 2013 | mcox
Philips Gem Topaz - Does anyone have a decoder ring for calculating the correct place angle for components. I am looking for a fool proof way to program the correct angles depending on how the parts are supplied to the machine. Thanks Mike
Electronics Forum | Mon Oct 07 06:32:07 EDT 2013 | kabo
Hello, angled camera only as complement to straight down camera.Many of benefits of angled camera is possible to reach with variable direction of illumination.
Electronics Forum | Fri Jan 21 10:02:18 EST 2005 | Steve C.
We have 2 different wave machines. An Electrovert with a foam flux and a Vitronics with a spray flux that is no-clean. We started noticing on the Vitronics that we were flooding inside the wave fixture. After further review we noticed that the angle
Electronics Forum | Mon Oct 07 22:06:43 EDT 2013 | action_101
I successfully inspect solder on plcc's with angled cameras on the yestech we have. In the past I have successfully inspected for solder with angled cameras on mirtec machines for both plcc's and qfn's. Other than inspecting solder on those two types
Electronics Forum | Thu Jan 13 10:30:14 EST 2011 | SheanDalton
My recollection is 6 degrees; but, I suspect the type of wave formation on the backside has an effect. Here's a few notes from an old fishbone chart: Too low angle: excessive solder, icicles, bridging High angle: insufficient solder, voids or outga
Electronics Forum | Fri May 10 15:02:28 EDT 2013 | dontfeedphils
In my experience, no. There are some uses for angled cameras (I've used them for inspecting off marks like notches out of LEDs for polarity), but I never found the results repeatable enough to warrant using the angled cameras over the standard, stra
Electronics Forum | Fri Apr 02 22:01:19 EST 1999 | Dean
| Anyone knows what is the optimum squeegee angle for screen printers. | | 45 Degrees. The forward velocity creates a downward pressure equal to the vector pressure (equalibrium). This is commonly known as paste "rolling action". Too obtuse an an
Electronics Forum | Thu Dec 18 21:36:03 EST 2003 | pdeuel
Blade angle, print speed, squeegee pressure, should be used in conjenction with one another. The more parellel the blade is to the stencel the more it will tend to float over the solder and the more paste is forced thru the appature. Contrary the gre
Electronics Forum | Mon Jul 13 05:54:39 EDT 2009 | rway
Hello all, We are looking to purchase another AOI system with side angle cameras. Currently we are using a YesTech M1 system that has only a top-down camera (it can't be upgraded with side cameras). Does anyone have experience with YesTech F1 sys
