Electronics Forum | Thu Nov 02 22:29:47 EDT 2023 | murtaza
Burn that machine. I had 3 of them and i was fixing it more than running boards
Electronics Forum | Thu Aug 17 13:55:45 EDT 2023 | markhoch
I think we need more information. Is it moving at all? Does it move to a reference position and then stop before returning to the home position? Have you verified that all sensors are working correctly? Does the machine use stepper motors, motors & e
Electronics Forum | Thu Aug 17 14:35:47 EDT 2023 | lauri
Thanks for the response. We have checked everything except the stepper motor, which we will try. But as we were checking everything now we've developed a software (?) problem. A msg comes up "can't find DSP".
Electronics Forum | Fri Oct 13 10:36:51 EDT 2023 | barty
Hello! To download TikTok videos and then watch them without internet access, https://savetiktok.org is the perfect solution. This service allows you to download videos and save them to your device, allowing you to enjoy the content even where there
Electronics Forum | Fri Oct 17 09:31:21 EDT 2014 | rgduval
To be honest, I have never had success wave soldering or reflow soldering batteries, regardless of their intended use. If you're going to continue a manual operation to solder one pin, I'd suggest that you just solder the entire component in by ha
Electronics Forum | Fri Oct 17 15:23:28 EDT 2014 | davef
First, don't exceed the maximum temperature of the battery, say 85*C [I don't know your specifics] Second, don't short the terminals of the battery. Third, the best way to wave solder a battery is: * Insert an insulating tab between the battery an
Electronics Forum | Mon Jun 05 05:41:48 EDT 2000 | casi
I need to find info about testing and probe contact about wifers with bump on pads. Thanks a lot to everybody that helps me
Electronics Forum | Tue Apr 24 21:00:58 EDT 2018 | marlonbc
Hi All, Would just like to course through this concern on a product that we are contracted to assemble. It is mainly used for an automatic hand sanitizer dispensing product. By design there is a restrictive value of current that it needs to dissipat
Electronics Forum | Thu May 21 18:11:37 EDT 2020 | gabriel1blue
Thank you for your reply. I tried to contact Panasonic support but even them have a hard time getting information on this machines. I have been waiting for them to let me know if they help us but no luck yet. I did replaced the a few backup batteries
Electronics Forum | Fri Jan 27 15:39:08 EST 2006 | GS
Thanks Patrick yes I feel better now, but allow me a comment: Reason A: your answer confirms my tough. In general could be accepted Reason B: your answer "The primary function of ups start when electricity is "off" so the equipment is clearly exem