Electronics Forum | Fri Nov 05 22:45:04 EDT 2010 | wingding
Does anyone know where to but parts for Hover Davis feeders. I need a 18 ½ x 1/8 inch drive belt for a Fuji feeder.
Electronics Forum | Sun Feb 03 09:36:29 EST 2019 | bobpan
Good job.... Sorry i didnt see this post...some of us were busy snow tubing over the weekend...haha. Many times over the years....the rubber belt inside the feeder will deposit material inside. Sometimes it ends up on the sensors and blocks the ligh
Electronics Forum | Sun Nov 07 21:00:15 EST 2010 | mainenetservices
sounds like its probably a timming belt. stock drive products is the place i go for robotics mechanical stuff, They likely have a sutable belt if you can get a good mesurement on everything(mesure the pully teeth, the belt may be streched). https://
Electronics Forum | Mon Aug 29 19:41:07 EDT 2022 | assuredtech
I'm not positive on the SFN3 but I have three of the MBF80-SOL which might be more inline to what you are after for 8mm package. It haa 5 lanes. It sounds like the MBF80 is... MBF80-SO/SOL 6-Lane Belt Feeder, 3 SOL, 3 SOIC. 3 SOLIC + 3 SOIC. Edward A
Electronics Forum | Wed Aug 31 07:23:42 EDT 2022 | leeg
We also use MBF feeders, sadly the belts perish and you can no longer purchase the original belts
Electronics Forum | Mon Dec 12 09:02:30 EST 2022 | peterm
You teach the corners of the component picked from the previous steps. Just select "PTF RR BTWN RAIL" slot 75 in "feeder teach" and it should move over to the belt.
Electronics Forum | Mon Dec 12 09:56:07 EST 2022 | peterm
Feeder Teach. Then it's the "Slot X,Y feeder teach" in the pulldown menu. That should be the default one, set feeder slot and the PTF as your feeder. If in doubt you can always make a back up in the feeder database as well. Probably a good idea eithe
Electronics Forum | Thu Dec 01 14:48:48 EST 2022 | peterm
Hi, The detailed instructions should be in Voyager under PTF Installation. It's basically a kit where you pick up a metal plate and you teach that component on the belt directly. If you don't have access to the kit I'd just start of with the default
Electronics Forum | Mon Dec 05 09:14:14 EST 2022 | peterm
Invoke. The PTF Setup Procedure dialog box displays. 4. Select Product. The Select Product File dialog box displays. 5. Select the same product used in the Open PTF Teach Product section above. 6. Enter the Slot number for the PTF and select Full
Electronics Forum | Thu Jan 19 09:41:47 EST 2012 | charliedci
We have the same issues with QFN's on reels being cost prohibitive, so we also have to deal with tubes. We have had some luck with using a modified tube ran down (almost to the pick position) the channel of a belt feeder, assuming the QFN tube/channe