Electronics Forum | Thu Oct 30 15:07:40 EDT 2008 | jemills
Hello I have a new 0402 pad design on a recent board were building in future. On closer look i thought the pad was a thru hole mount , but upon closer inspection the round pads are for 0402 comps. I had a discussion with the engineer and he said
Electronics Forum | Wed Mar 17 14:59:53 EST 2004 | Claude_Couture
since there is a bit of humor in this thread, try drilling the pads from the opposite side of the pcb.
Electronics Forum | Fri Mar 19 10:06:22 EDT 2010 | karlo
Rework is typically done by heating the BGA to 170-180C to first scrape off the fillet. Then, heat to above reflow, and lift the BGA. Then, collapse the solder with heat and flux. Then, back down at 170-180C, scrape off the underfill from the boar
Electronics Forum | Wed Jul 14 16:59:52 EDT 2010 | swag
Solder paste on the pads will keep part aligned. If you do not use paste, you will need to apply tacky flux. You should not run without one or the other.
Electronics Forum | Fri Feb 19 05:08:40 EST 2016 | truewanderer
Thank you Tsvetan Usunov
Electronics Forum | Tue Feb 16 13:58:02 EST 2016 | tsvetan
this document http://www.latticesemi.com/view_document?document_id=671 may be good start point but note that how to escape from the BGA is not big deal, how to route your filtering capcitors, grounding, impedance control lof you high speed signals ar
Electronics Forum | Fri Feb 19 05:14:04 EST 2016 | truewanderer
Hi, i have a confusion to read the dimension of BGA package from the datasheet. I have attached the datasheet below. Is this diameter of the ball 0.30mm or 0.15mm. I'm confused about the values given in the box. Whats meant by M, S, A and B. Please g
Electronics Forum | Thu Feb 11 07:24:40 EST 2016 | truewanderer
I'm planning to design the pcb of my project. The controller used is having 136 pins and the package is P-LFBGA. So i think i need to design a 6 layer board for better performance. I haven't designed a multi layer board before. So what are things tak
Electronics Forum | Sat Oct 06 08:42:21 EDT 2001 | davef
Please give us additional background on your board, solder, process, etc. If you are talking about black pad in ENIG solderability preservative, check the fine SMTnet archives to get started.
Electronics Forum | Fri Aug 22 00:20:29 EDT 2008 | rameshr
Hai, In our process we are using the micro bga of size 13X13mm of pitch 0.45mm,after soldering process the bga found collapsed, we absorbed that the PCB land pattern of the BGA was not in array, uneven distribution of pads (area) & most of the pads