Electronics Forum | Fri Aug 22 03:19:08 EDT 2008 | andrzej
Hi, what do you mean by collapsed ? Can you describe or send a photo ?
Electronics Forum | Mon Aug 25 08:44:10 EDT 2008 | rameshr
Dear Andrezj, i had attached the photos for ur reference Kindly advice.
Electronics Forum | Wed Aug 27 00:20:38 EDT 2008 | rameshr
Dear davef, Will u pls advice what are all the possible defects caused while soldering ( assembling ) this type of boards.
Electronics Forum | Wed Jul 01 04:54:28 EDT 2015 | jvercamm
hi, the last post on pad cratering dates from 2012. We have (likely similar) problems with a RoHS 783 solder ball BGA size 29x29mm^2 (organic package BT), pitch is 1mm and solder ball diam is 0.5mm the field failure is after 12 months, almost exclu
Electronics Forum | Thu May 05 12:00:16 EDT 2005 | russ
Bad cleaning practice is suspect. It is believed that W.S. flux was used to solder adjacent components and then hand cleaned. This is not definite but it is pretty certain.
Electronics Forum | Wed Sep 15 07:29:23 EDT 2004 | kbayram
Thank you Rob for all the help, it has cleared up a lot of things. The smtsales site looks good too, I'ill definitely be giving them a call when the time comes. Thanks again.
Electronics Forum | Thu Aug 17 09:57:16 EDT 2006 | jwn
Hi all, I need to find a solution for a problem I have. I need to replace BGAs which have been glued to a laptop board with superglue (Loctite). How can it be done without removing the pads when trying to remove the foreign glue? thanks in advance
Electronics Forum | Wed Mar 14 13:16:54 EDT 2007 | Shane
I have a customer that designed a fine pitch BGA into a board, and has put small vias in the middle of each pad on the PCB. Anyone have any ideas on how I can prevent the solder from the BGA from flowing through the vias and causing voids or no cont
Electronics Forum | Fri Jun 17 23:31:12 EDT 2005 | kenscj
Hi all, currently, we are seeing BGA problem like solder ball misalign, void, solder short (all under BGA, tested with 5DX), after reflow. We examine the solder ball (raw material of BGA), and see that the ball surface is not smooth, will that affe
Electronics Forum | Fri Nov 27 00:36:02 EST 2015 | slouis2014
I just encountered a BGA design were in, underneath the BGA is a silkscreen that covered the entire bottom of the component except for the copper pads. Can you give any information and advice for this type of design.