Electronics Forum | Mon Jul 20 06:46:50 EDT 2009 | brucow
Hi All, If anyone knows the default password to enter the BIOS on the Philips Comet 1 machines it would be much appreciated if you could post it here. I am trying to replace the hard drive in our machine with a standard 4GB unit formatted to 40Mb bu
Electronics Forum | Thu Dec 11 02:24:37 EST 2014 | vladicac
We found out what was the problem. If you happen to get the same error be sure to check if you have access to all COM ports. Also check CMOS battery. Because of low battery voltage all BIOS settings were lost. Because of that we had to reconfigure ou
Electronics Forum | Tue Oct 04 03:36:23 EDT 2016 | oxygensmd
Today we replaced the HDD to another one. The old HDD is in working condition that is why we can make a new copy-backup from that. We realized that the BIOS didn't see the HDD sometimes. Now we adjusted the BIOS to the right setup, replaced the batt
Electronics Forum | Wed Oct 13 15:41:31 EDT 2021 | dilogic
Aside from BIOS settings for the drive, there's another page with EXM settings (that's the interface your EXM-9 board is using). You have to configure it right in order to get the system running. See attached document where settings are explained - r
Electronics Forum | Fri Feb 09 01:46:55 EST 2024 | erikfriesen
I have a 2005 DEK Horizon 02i, the cmos batt was dead, so I replaced, and reset the bios. The device hangs in initialization, eventually erroring out. The vision led's blink rapidly during this period. Also, the card shows an error in device manag
Electronics Forum | Mon Oct 16 17:46:49 EDT 2006 | Dan
Recently I was given a bad Bios Link from Toshiba which fried my Bios and now my laptop boots to a black screen. I recently unsoldered and removed the existing Bios chip and have ordered anotherfor replacement. Unfortunately while removing, i damag
Electronics Forum | Tue Nov 09 21:20:28 EST 1999 | Gyver
Hello all, Recently, we had a bad problem of block protection. You know, our programmer can't protect the 29F002 flash ROM, and our motherboard doesn't have 12 volts output for BIOS. So, from the preceding phenomena, it seems impossible to get a prot
Electronics Forum | Mon Nov 24 16:29:10 EST 2014 | kevinb
I have a Quad QSV-1 machine. It has been off for over a year with no power to it at all. I found out that I lost the BIOS on the machine. I have two QSV-1 with the serial numbers one apart from the other so I copied the bios from one to the other
Electronics Forum | Fri Jan 12 03:52:06 EST 2018 | kimseo
Hello dear, we have own SAMSUNG CP40CV pick and place machine. Today I had to change a battery in PC mainboard. It didn't work immediately. I had to open BIOS and load DEFAULT SETTINGS. Now I can start a computer but after Windows is started it will
Electronics Forum | Mon Oct 25 21:42:26 EDT 2021 | astarotf
thanks for the info. But we do not have the installation discs or the software to reinstall the machine. There is no EXM-9 calibration information or BIOS parameters in the document. We have already exchanged the old battery for a new battery on the
