Electronics Forum | Tue Aug 23 03:42:10 EDT 2005 | Adeline
presently, the production facing this problem. We has couple of brd which is electroylic gold finishing with plug via. The brd has blister after the PCBA (in lead free temperature, 265 degree) Some time, bare brd already has the blisters. But most of
Electronics Forum | Fri Jul 28 08:34:47 EDT 2006 | Chunks
What does your reflow profile look like?
Electronics Forum | Fri Jul 28 12:37:55 EDT 2006 | Chunks
Yes I agree with the termination problem and the Friday thing!
Electronics Forum | Fri Jul 28 13:55:12 EDT 2006 | mumtaz
Please. Why over engineer this the end. Simply wave solder them!
Electronics Forum | Thu Jan 19 20:40:52 EST 2006 | Gary Kemp
We are experiencing a blistering problem during our process of lead free assembly. The customer has supplied us with the bare fab rated at 140 Tg. I am under the assumption that the Tg rating should at minimum be 170. Does anyone know if there is
Electronics Forum | Wed Jun 23 13:34:29 EDT 2004 | df_indy
I am four weeks into my new job, there always seems to be some issues here with PCB every week. Today while I was checking some assemblies with micro-scope, I found a lot of tiny bubbles/blisters on the board. They are just little dots if you look
Electronics Forum | Tue Aug 23 22:50:09 EDT 2005 | adeline_ko
My process guy told me that. Due to black spot issue, brd with BGA must use electrolytic finishing. And when we had this finishing with plug via, the blister issue pop out. My supplier claim that this is due to the plug via. Which I don't know how
Electronics Forum | Tue Jul 18 18:53:23 EDT 2006 | Mike F
Is it showing up after wave or reflow soldering, or after hand soldering? If the delamination or blister bridges between traces you have the potential for a short circuit between those traces. A delamination might be repairable, but in most cases i
Electronics Forum | Tue Mar 23 14:08:57 EDT 2010 | davef
You have what looks to be blisters/delamination. Use IPC-A-600F as a guideline for acceptance. Usually, we start from the opinion that blisters/delamination as a fabrication issue, even if it appears during solder processing. Often blisters/delam
Electronics Forum | Sun Aug 17 19:06:42 EDT 2014 | natashakt
Hi All, I have been looking in to some failures of PCB's in Assembly. After SMT the boards are stored for different periods of time in high humity environment (72% RH and 21.4 degrees Celsius) before being sent to Assembly to be handsoldered/put thr