Electronics Forum | Tue Oct 03 17:44:23 EDT 2006 | SWAG
I am trying to get a CyberOptics SE200 on line. Does anybody have any idea why the SMEMA interface is always telling the downstream machine that a board is available? It will not switch off no matter what running condition the machine is in - even
Electronics Forum | Wed Aug 22 04:29:48 EDT 2007 | raf_jabil
Has anyone experienced intermittent communication issues with GSM/GDM and PCT conveyors? I have an intermittent issue where sometimes I would hit the ESTOP on the PCT conveyor(downstream) in order to get the board to eject out of the GSM/GDM. I have
Electronics Forum | Wed Sep 18 16:56:55 EDT 2002 | stockley
I started writing a long winded explanation about SMEMA and realised that it is just as easy to write about this as it is to talk about it on the phone. It just so happens that I have recently gone through this process so I believe that your vendor
Electronics Forum | Thu Jul 28 18:53:32 EDT 2011 | rway
Make sure your system is not in bypass mode (under conveyor setup). Also, the intermittent SMEMA signal can cause the conveyor to turn on until it times out. Check your sensor on the upstream conveyor. Cover it and check your diagnostics to ensure
Electronics Forum | Thu Sep 29 19:11:47 EDT 2011 | swag
Now I see - not sure. The only trouble I've had that was similar was because an electronic eye on one of the stages was seeing a machine that was installed a couple inches over the top of the conveyor. We had to install a flat black plate on the ma
Electronics Forum | Mon Oct 16 16:05:59 EDT 2000 | CAL
Brian- IPC has SMEMA Down loads for communication protocal: http://www.ipc.org/html/fsresources.htm. Also, I interfaced a fuji CP6 with a Siemens s20 and had to put in a relay and sensor to complete the communications loop. Fuji uses a 24v on/off com
Electronics Forum | Thu Jul 28 21:32:06 EDT 2011 | rway
We are using 2.7.7. I have two M1 systems, but the sw is the same. I am not at work at the moment, but I will look tomorrow and let you know. On a side note, the conveyor will run continuously when in bypass mode. It does sound like you have a tra
Electronics Forum | Fri May 01 15:35:03 EDT 2020 | travishemen
I'm not sure if these are similar to our Genesis machines but if they have removable feeder banks they are part of the safety circuit. If they are not installed or if the sensors on them are misaligned it will show the same as an interlock violation
.gif)
