Electronics Forum | Sat May 09 09:10:19 EDT 2015 | sarason
Might I add, avoid Y5V if you want a reliable design and Marc is correct do look at those charts for X7R voltage dip under load, if you are doing low volume, save yourself the trouble and time, just overrate. sarason
Electronics Forum | Sat May 09 09:12:53 EDT 2015 | sarason
Might I add, avoid Y5V if you want a reliable design and Marc is correct do look at those charts for X7R voltage dip under load, if you are doing low volume, save yourself the trouble and time, just overrate. sarason
Electronics Forum | Wed Apr 26 05:03:30 EDT 2006 | Darren
Hi We have a new product that has a 22uF 0805 X5R 6.3V Chip Cap. It is placed on standard 0805 pads but is 1.25 mm high and although we are not getting the best fillet it appears sufficient. The trouble is we are getting a small number of returns
Electronics Forum | Wed May 10 12:13:16 EDT 2006 | scombs
We have a 6 up panel with a 1206 part .082" from the board scoreline. After depanelization when we run the board through ICT it fails for a short at that location. We have visually inspected at high magnification for any cracks in the body and at the
Electronics Forum | Mon Aug 21 10:36:25 EDT 2006 | vikkaraja
I Think I understand your problem. But I think it would be best if you just go in the program and change/check your componet height as needed. It does not take much time. Check your cap height, modify shape data as needed, generate your program and
Electronics Forum | Thu Apr 19 16:54:32 EDT 2007 | flipit
I don't suggest using Pd/Ag or Ag/Pd terminated components unless you are forced to use them. You often see a line of demarcation that suggests a poorly wetted solder joint. I have had bad experiences with Pd/Ag terminated capacitors. Even when so
Electronics Forum | Mon Aug 07 04:25:00 EDT 2000 | dougie
Hi Guys, Thanks for the response. To answer your questions... The compoments we are placing and experiencing trouble with are generally 1206 components. It isn't just one manufacturer either. The one part though we have most problems with though is
Electronics Forum | Wed Oct 06 09:23:47 EDT 1999 | Wolfgang Busko
| I would like comments on how the industry handles 0402 parts, regarding identification. Since the parts are too small to be labeled, how can we accurately identify the parts and or values, either before or after assembly? | When the boards go to te
Electronics Forum | Fri Jan 22 18:54:54 EST 1999 | Steve Gregory
> If you are inheriting a system, you probably don't have a lot of choice, >>but with a little ingenuity, you can pull a Steve Gregory: Grab some duct >>tape, a book of matches, and a videotaped rerun of MacGyver for >>inspiration. HEY! Whaddya mea
Electronics Forum | Tue Aug 10 15:19:09 EDT 2004 | davef
Hey Bob, turn DOWN the volume. Waint daff yano!!! On the surface of things, if you�ve been to a dozen board houses that have not been able to properly separate boards, we�d kinda be inclined to think it�s you and not them. [In your defense, we hav
