Electronics Forum | Wed Sep 13 20:58:50 EDT 2000 | Dave F
If you don't know what you have, how the blank are we sposed to tell you? Try your local fab. CEM1 - Opaque tan CEM3 - Translucent FR2 - Opaque brown FR3 - Opaque cream FR4 - Translucent FR5 - Translucent FR6 - Opaque white G10 - Translucent G11 -
Electronics Forum | Thu Sep 14 09:53:09 EDT 2000 | John Thorup
Cheap and beige = CEM1 Dave has good advice. Go to a fab that you use and ask them. My concern is that you are not getting enough documentation to do your job correctly. If your customer expects you to duplicate a sample they had better spec what th
Electronics Forum | Thu Feb 03 06:21:57 EST 2000 | Ignacio Simon
I would like to have information about the materials commonly used for laminates of printed circuit boards, their main thermal, mechanical, humidity and electrical characteristics and proper finishing and aplicattions, and advantages/disadvantages be
Electronics Forum | Wed Feb 14 16:38:00 EST 2018 | cbart
i have seen that happen when the wrong process was utilized! your boards looked like they were v-scored and someone broke them apart, proper method would be to use a scoring separation machine.. pizza cutter. this would prevent this. its not a good i
Electronics Forum | Mon Oct 16 11:12:42 EDT 2000 | NLykus
CEM 1 is a laminate base board material. The other boards in the experiment were manufactured using FR4 as the base board material. What I'm leaning towards is that the glass transition temperature "Tg". What do you think? Topside temperatures in
Electronics Forum | Wed Sep 13 17:51:01 EDT 2000 | Francois Racine
My question is concerning a cheap PCB material. I have a sample with me and I have to quote on this product with the same PCB material. This material is not FR4 and the color is beige. I think CEM-1 material is beige too but I`m not sure. I`ve hea
Electronics Forum | Thu Dec 26 08:40:21 EST 2013 | vileo72
Hi , During one of NPI trial ,we found that boards ( CEM -1 grade )has got discolored on the masking portion ( and not on the conductors) after reflow .Although it does not impact our Form /Fit and Function characteristics , I would like to get your
Electronics Forum | Sat May 24 21:49:24 EDT 2003 | ramanandkini
We have an electronic circuit with a miniature stepper motor, quartz crystal, Electrolytic capacitor,chip resistors and few smt LEDs. The PCB material is CEM1 with SMOBC and HALS finish. This circuit is assembled in a plastic casing and goes in to a
Electronics Forum | Fri Jun 04 01:13:31 EDT 2010 | boardhouse
Hi fotis, Big difference between Cem3 & FR4 is that FR4 the glass is woven and Cem3 is sheet glass non-woven. for Multi layer product, i would not consider Cem3 due to increase chance of de-lam due to lack of weave for strength. Cem1 and Cem3 are
Electronics Forum | Wed Oct 18 16:41:35 EDT 2000 | Dave F
It's unrealistic to think that two materials with the following disperant properties would have the same reflow profile. From http://www.norplex.com/Carrier.htm Physical Properties / NEMA FR-4 / NEMA CEM-1 Glass transition temperature �C / 130 / 10