Electronics Forum | Fri Jan 13 14:18:41 EST 2006 | mark
Hi, I would like to ask you how you test the PCB (electrical test) of first PCB before starting production.? What kind of equipment you are using? and method to confirm that components on PCB are correct (value, orientation, describtion, polarizatio
Electronics Forum | Fri Jul 30 11:32:31 EDT 2004 | westred
I am looking for a fool-proof way to have operators measure PCB's out of the depaneler to ensure that the tolerances for the outside edges are being met. Probably a spot check system to make sure the process is in tolerance. So far building a "GO"
Electronics Forum | Mon Apr 23 10:22:02 EDT 2018 | robl
It also depends on how good your auditors are. We are very tight on calibration and maintenance across all sites but it's definitely the UK auditors that drive us to be better. They are the ones who match historical builds against tool calibratio
Electronics Forum | Fri Jan 13 14:21:56 EST 2006 | chunks
We always have the board house do it. Why catch bad board for them? Don't let them push you around.
Electronics Forum | Fri Sep 11 01:06:28 EDT 2009 | boardhouse
Hi you can try fab3000 - down loadable off tucows. http://www.tucows.com/preview/513130 They say its free. Regards, Boardhouse I have no affiliation with Fab3000 or Tucows
Electronics Forum | Fri Sep 11 08:36:22 EDT 2009 | leemeyer
Thanks Boardhouse, This looks like it will work. Unfortunatly the free version does not pinpoint the violations but it does let me know that they exist somewhere on the board. It's a relatively inexpensive upgrade to get the version that will pinpoi
Electronics Forum | Thu Apr 19 13:45:43 EDT 2018 | wolverine55
Hello All, I was told that if the plant that I work in got an AS9100D certification then as the Facility Maintenance Mgr I would not be allowed to use any of my personal tools in the course of doing my job, which includes maintenance and repair of SM
Electronics Forum | Thu Apr 19 18:38:05 EDT 2018 | slthomas
I would say not likely unless it's at least serialized, but certainly so if it requires calibration....point being LOTS of stuff requires calibration for AS9100 activity. Simple hand tools probably not, for example, but your calipers, multimeters w
Electronics Forum | Fri Jan 13 15:55:07 EST 2006 | DannyJ
Hi Mark, I'm guessing from your letter that you are not asking about traces, just component values. We use a tool called 'smart tweezers' (catchy, eh?) to do jsut what you are asking. Very easy for our QA department to use a BOM to compare agains
Electronics Forum | Thu Apr 19 17:01:36 EDT 2018 | davef
It's likely. Under any of the XX9100X standards, all procedures, including repair & maintenance, must be documented. The procedures define the proper steps and tools that are acceptable for people to do something. Procedures define the way your com
