Electronics Forum | Tue May 26 18:17:22 EDT 1998 | Jerry
Our experience has been that mechanical crack occur vertically through the chip. In other words perpendicular to the board surface. You can sometimes tell through close inspection that the crack may have propogated from a point that the nozzle may
Electronics Forum | Fri Jan 11 02:07:08 EST 2002 | ianchan
For repeated model runs, we go ahead with the SMT run, whilst the QA does the FA inspection. Limit FA timing to 2h or less...(simple boards yield faster time cycles). For new model runs, yep, we wait for QA to confirm the FA inspection, only with QA
Electronics Forum | Mon Sep 11 03:52:14 EDT 2006 | aj
Hi All, this has not happened but I would like to know what the possible effects would be if we ran a non-rohs pcb (hasl) thru a leadfree Process. We have a customer who cannot confirm if the board is rohs compliant or not and we are waiting on con
Electronics Forum | Mon Nov 27 08:10:08 EST 2006 | Loco
Dear all, I'm having a friendly discussion with our chief manufacturing engineer. To our PCB suppliers we specify the use of "chemical gold", imo this means we use ENIG, Our boards are all copper under the solderresist which imo further confirms we
Electronics Forum | Mon Nov 19 17:40:38 EST 2007 | bbarton
No, the thicker plating and need for very high quality drilling and plating is DUE to the higher copper dissolution rate and higher contact time. As to the Sn100C material, their claims seem to confirm a "lower" copper dissolution rate, but so does A
Electronics Forum | Tue Sep 14 00:35:47 EDT 2010 | sachu_70
The PPS helps to prepare a program off-line without affecting on-line production. However, there are certain efforts that we must consider, such as identifying the part orientation on feeder vis-a-vis its placement orienation on PCB, and confirming s
Electronics Forum | Tue Apr 28 09:27:53 EDT 2020 | assuredtech
On power up, push and hold the F1 key during the complete boot up, this will force the machine to boot into it's I/O menu, this allows you to verify the conditions of all of the sensors and confirm if it is waiting on an input from a sensor. Most com
Electronics Forum | Tue Jul 25 11:04:03 EDT 2000 | rene
Lately I have noticed that many manufacturers of electronic (components) have problems in setting up their logistics structure in Europe (availability of parts, spares, reverse logistics, RMA shipments, leadtime constraints). Is there anyone who shar
Electronics Forum | Mon May 01 03:22:01 EDT 2000 | Jackie Hsieh
Yes,the Fujicam optimize your production program will happen something wrong, such as the placing order is from bigger componments to smaller ones, and the order of the D-table is out of order,and.....no efficiency on the optimizing.......... So, I c
Electronics Forum | Fri Apr 21 14:31:20 EDT 2000 | JACOB LACOURSE
I FOUND THAT ONE OF THE MANY REASONS FOR TOMBSTONING COMPONENTS IS MOISTURE IN SOLDER PASTE. ONE WAY TO CONFIRM THIS IS TO CHECK FOR EXCESIVE SOLDER BALLS AROUND THE PART IF THEY ARE PRESENT THEN YOU MAY HAVE A HUMIDITY PROBLEM. GOOD LUCK!!! JAKE