Electronics Forum | Fri Jul 28 14:34:13 EDT 2000 | Gary Simbulan
Belive it or not, these boards were run through a Centech batch mode Vapor Phase machine. Single stage top side IR preheat. Vapor temp 218 C. Solder paste is an SN62 RMA.The boards were FR4 8 layer w/ solder mask, fairly conventional as might be e
Electronics Forum | Wed Jan 15 07:28:15 EST 2003 | Jean-Philippe
Its not really an electromagnetic device, its just a feeder for connectors.
Electronics Forum | Wed Feb 16 16:41:31 EST 2005 | Mrduckmann2000
Pallets will not work in this case because the wonderful designers put 0402's between the legs and all around the legs of the thru-hole connectors. There are 18 thru-hole connectors on this board and 200 - 0402's around them. The 0603's that are al
Electronics Forum | Thu Apr 07 14:05:53 EDT 2022 | SMTA-69080803
@cbart It's a mid-volume product and as I said, there are several boards (slightly different layouts) using the same component. When you say ISI, do you mean connectors? can you give me an example of what you used in the past?
Electronics Forum | Thu Jul 06 13:36:37 EDT 2006 | SWAG
We've had much trouble with flex circuits. As previously mentioned, you must have local fids for the board or the BGA itself (if panelized). Other troubles we experience are drilled holes for pinned connectors. Unless the PCB manufactur has some w
Electronics Forum | Mon Jun 26 08:54:35 EDT 2006 | dougs
We have a new product in where a 0.7mm pitch uBGA is to be placed on a 2 layer flexi board. Also a 20thou pitch connector. Has anyone done anything like this before, what should i look out for. Not done much flexi work before so any tips will be g
Electronics Forum | Sat Jul 29 09:10:16 EDT 2006 | davef
Ball Grid Array (BGA). A surface mount technology leadless package with the connectors to the board placed in an array on the bottom of the package. They are attached to the board with tiny balls of solder placed on each contact. Pin Grid Array (P
Electronics Forum | Mon Dec 18 23:24:50 EST 2006 | grantp
Hi, Yes, I would hate to resort to cleaning, but the product must be clean. We have been using palettes to keep most of the flux off the PCB, but there is still residue around the connectors. Does anyone suggest a good no clean flux to use with le
Electronics Forum | Wed Jul 26 18:23:47 EDT 2000 | Gary
I have been following forum discussions here and eslewhere, attended technical sessions at APEX and have been experimenting with the paste-in-hole process on some of our new product. I have run into one problem I have never seen mentioned, that is a
Electronics Forum | Mon Jun 26 12:23:11 EDT 2006 | Rob
Yep, Book a holiday and let someone else sort it out. Otherwise e-mail me and I'll talk you through pallets, rigidisers, printer tooling, spray mount, Kapton tape, local fiducials (panels can strech & shrink) etc. Oh, yeah - for the connectors you
