Electronics Forum | Tue Jan 28 18:38:36 EST 2003 | joeherz
Mike, I've tried the high side of the flux preheat spec with no success. I did just get off the phone with Electrovert tech support...... Get ready. This machine is configured with a Contour Plus N2 nozzle. We are not running N2. According to M
Electronics Forum | Wed Aug 15 06:16:30 EDT 2001 | JohnW
Ok so an update on the ceramic board. I've had some success but did have to cheet a little. So Dave, on the fluxing, your right we're not getting it all the way up the barrel and in the end as a short term fix we're dipping the lead's in flux not th
Electronics Forum | Fri Jan 13 22:57:19 EST 2006 | John
The New Redesigned Vectra , should fit right into the same price range as most mid-range wavesolder machines offer by most. We are looking to replace a existing Delta Wave and found the pricing about the same.But The upgrade prices can be high for no
Electronics Forum | Thu Aug 17 14:20:49 EDT 2006 | Jay Hardin
Hello everybody, My name is Jay Hardin and I'm the MS2 Applications Manager for P. Kay Metal. I was just informed of this thread and will post my 2 cents when needed. I'm the guy who goes out in the field and makes sure MS2 is installed properly and
Electronics Forum | Thu Aug 31 19:40:22 EDT 2006 | cardinal
A couple things on the Grid-Lok system. They now offer a top-side edge clamping system. The edge clamping system works very well for warped, twisted boards etc.. Using this system in the auto mode also allows the pins to contour to the geography of
Electronics Forum | Wed Mar 20 13:18:26 EDT 2013 | kmots15
Is printing your concern or placement. I would say both: Printing: At 5 feet and on a flex you better have a really nice fixture to keep everything in check. You'll probably have to hand screen it unless your going to get a dedicated custom continu
Electronics Forum | Fri Feb 20 12:55:43 EST 2004 | russ
Ah, the old contour wave. I don't really know how to adjust those to get correct backflow to reduce your solder volume. I need to ask why you are worried about this. Do you have a QC requirement in excess of IPC class3 wich allows for this joint t
Electronics Forum | Thu Oct 08 12:11:34 EDT 1998 | Rick Wyman
| Does anyone know of an AOI system that can look at the solder joints of SMT chip devices (1206,0805 & 0603) and make a reliable presence/abscence call of the joint on a HASL PCB. A low false call rate (much less than 1%)is required. Any info. fro
Electronics Forum | Mon May 23 10:53:32 EDT 2005 | HOSS
Eric, We also have a UPK 650C. Our machine was configured for N2 and using the ConTour nozzle. If you're using this nozzle without N2 you're creating tons of dross unnecessarily not to mention probably getting tons of icicling. We found out the h
Electronics Forum | Mon Sep 21 20:45:55 EDT 2009 | davef
10.4. Pre-Cure Examination. Immediately after material application, the uncured conformal coating shall be examined for: a. Bubbles and Air Entrapments. These defects shall be broken by vacuum, with a sharp probe, or other appropriate tools. b. Bridg
