Electronics Forum | Thu Mar 04 07:57:32 EST 1999 | John Godfrey
I need to setup an oven to run with a nitrogen atmosphere for boards with BGA's, but our ovens do not have the optional atmosphere monitor and controller. Is there a good way to sample and control the atmosphere without the optional built-in atmospe
Electronics Forum | Mon Oct 01 19:44:49 EDT 2007 | marcelll
Just bought a used VIP 98 and I have an alarm. Computer don't communicate with the embedded controler of the oven. I've check the cabling, OK, and there's power on the controler. The PC is booting normally. The controler is plug in the serial port 2
Electronics Forum | Fri Sep 14 13:00:28 EDT 2012 | mark25y2001
Try to check encoder if properly locked, also check encoder connector if properley inserted, if all good, it's possible that the conveyor controller or encoder problem... to check controller related just try to set in zero value, then if conveyor are
Electronics Forum | Mon Nov 23 15:37:49 EST 2015 | davef
Primary ISO clean room standards are: * ISO 14644 Cleanrooms and associated controlled environments * ISO 14698 Cleanrooms and associated controlled environments -- Biocontamination control An introduction to ISO 14644 Cleanrooms and Associated Co
Electronics Forum | Mon Feb 28 14:01:03 EST 2000 | greg
I have the following problem with a GSM. When powered up I get the error "Error Initializing Hard Disk Controller 0" do you think this is the controller if so what is the part number for a controller.. any input would be great thank you
Electronics Forum | Mon Feb 28 14:01:03 EST 2000 | greg
I have the following problem with a GSM. When powered up I get the error "Error Initializing Hard Disk Controller 0" do you think this is the controller if so what is the part number for a controller.. any input would be great thank you
Electronics Forum | Fri Nov 19 15:17:36 EST 1999 | Vahid Vatannia
I just started my new job and I noticed that the humidity on production floor (electronics) is not being controlled. I have some basic understanding of why we need to control temp & humidity. Do you know if there is any benchmarking/studies done on t
Electronics Forum | Thu Apr 04 09:22:35 EST 2002 | itempea
What are the normal control limits in the industry, for a well controlled process, using a 6 mils stencil? Should they be different according to the surface finish (higher UCL for ENIG, Im SN, etc, lower UCL for HASL)? Thanks, Ioan
Electronics Forum | Wed Sep 10 06:58:30 EDT 2003 | fpcb
these machines are controled by a panadac 783 which has memory for 8 programs. How you can control these machines by a computer ? There is ,as I have heard, a Panasonic program host. what can it do , Is this the solution ? Thanks John
Electronics Forum | Mon Nov 21 04:57:48 EST 2005 | rlackey
Hi, Yes you can use a PWM (Pulse Width Modulator). This is much more efficient than a large resistor & gives you good control. Here is a sample for 12V motor control: http://www.homepower.com/files/pwmhp75.pdf