Electronics Forum | Thu Jun 17 19:41:29 EDT 1999 | Scott Cook
| | first of all what is the technical term for the small amount of solder on a plated pad. we are getting poor screen printing gasketing on a 20 mil qfp due to this solder not being even or too high in spots and not covering the length of the pads.
Electronics Forum | Fri Jun 18 10:24:12 EDT 1999 | John Thorup
| first of all what is the technical term for the small amount of solder on a plated pad. we are getting poor screen printing gasketing on a 20 mil qfp due to this solder not being even or too high in spots and not covering the length of the pads. an
Electronics Forum | Thu Jun 17 21:24:32 EDT 1999 | Dean
| first of all what is the technical term for the small amount of solder on a plated pad. we are getting poor screen printing gasketing on a 20 mil qfp due to this solder not being even or too high in spots and not covering the length of the pads. an
Electronics Forum | Thu Jun 17 20:48:18 EDT 1999 | Earl Moon
| | first of all what is the technical term for the small amount of solder on a plated pad. we are getting poor screen printing gasketing on a 20 mil qfp due to this solder not being even or too high in spots and not covering the length of the pads.
Electronics Forum | Fri Jun 18 11:33:16 EDT 1999 | Brian wycoff
| | first of all what is the technical term for the small amount of solder on a plated pad. we are getting poor screen printing gasketing on a 20 mil qfp due to this solder not being even or too high in spots and not covering the length of the pads.
Electronics Forum | Wed Sep 02 08:52:13 EDT 1998 | Justin Medernach
| | We are experiencing shorting on a BGA. The part has a 1mm pitch with a 196 I/O count. The problem seems to pop up without warning & disappear in the same manner. | | Our pad design is .020" diameter pads with .025" solder resist diameter. Th
Electronics Forum | Fri Jun 18 10:46:10 EDT 1999 | Scott Cook
| | | first of all what is the technical term for the small amount of solder on a plated pad. we are getting poor screen printing gasketing on a 20 mil qfp due to this solder not being even or too high in spots and not covering the length of the pads
Electronics Forum | Fri Jun 18 11:37:10 EDT 1999 | Earl Moon
| | | | first of all what is the technical term for the small amount of solder on a plated pad. we are getting poor screen printing gasketing on a 20 mil qfp due to this solder not being even or too high in spots and not covering the length of the pa
Electronics Forum | Wed Apr 17 13:48:32 EDT 2024 | jdengler
I have a AIMEX III and we have seen the top cover on the conveyor being pushed out of postion when someone does maintenance. I beleive the NXT's use the same configuration. Check to see that the cover is pushed all the way over where the PCB would
Electronics Forum | Tue Sep 25 05:58:16 EDT 2012 | bobpan
I believe the Led's should flash 3 times when the card is booting up/ powering up normally. There was no board troubleshooting back in the day and we just replaced the card. Make sure the metal cover is grounded to the machine.....this sometimes caus