Electronics Forum | Fri Jan 05 12:02:28 EST 2018 | ilavu
Camera works fine from home to ref. position to fiducial1 and 2. Problem shows up from home to board stop. AC voltage between AC1 and AC2 is 41.7 and during move it drops to 41.5.
Electronics Forum | Sat Aug 13 22:55:11 EDT 2022 | dekhead
Most likely an issue with vision system, or communication therewith... But with # of combinations of CPU, Cognex and cameras, would prefer off forum contact to sort it out. email sent.
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
Electronics Forum | Fri May 26 02:22:18 EDT 2000 | Sal
Generally a good and safe option when selecting a printer, A rhobust machine with good process capabilities. We print anything from 0402's to CCGA's using proflow, as well as print adhesive with no problems. The 265 ranges from the MK1 TO Infinity mo
Electronics Forum | Mon May 02 21:26:23 EDT 2022 | rob1
I have a problem with DEK 265 Horizon. During camera being homed after checking the fiducials, the camera failed to home properly and crashed into the back of the machine in the Y direction. I homed the camera in the Y and it appeared OK and I could
Electronics Forum | Sun Jul 14 16:46:38 EDT 2019 | rob1
I'm working on A DEK 265 Horizon and I need to convert it to right to left. I have changed the conveyor direction in software, however, the board stop position appears to be from 0 to 255 and I need it stop on the left hand side of the centre referen
Electronics Forum | Mon May 16 13:15:16 EDT 2022 | richardcargill
The camera crashing is usually a fault with the encoder on the Y motor assembly. someething to do with not finding a home pulse I think. Anyway, replace the motor/encoder and recalibrate and you should be good to go
Electronics Forum | Tue May 03 16:36:09 EDT 2022 | dwl
I don't know anything about DEKs so while you wait for a more informed response, here are a few brain droppings... Did something get knocked loose on the camera assembly? give everything a wiggle test and make sure it stays in place. Is the encoder
Electronics Forum | Sun Jul 18 12:13:06 EDT 2021 | oriolsancheza
Hello, Our machine started to not stopping board into the right position (stop pin was not working we guess). After some inspection we have not seen anything strange. However the DEK software decided to not work anymore. We've been messing arrounf
Electronics Forum | Mon Jul 15 09:03:44 EDT 2019 | dekhead
It uses the same BS position regardless of feed direction. In right feed, it passes Board under the camera and when (board @ stop) sensor detects board has passed, drops the BS and reverses conveyor direction. There is "Right Feed Delay" parameter to
