Electronics Forum | Thu Dec 26 12:51:32 EST 2019 | emeto
Very broad topic. Designers own design. Manufacturing engineers can suggest design changes based on DFM, DFX DFA analysis. These are suggested, so the board is manufacturable with very low to no rework. Both design and manufacturing have their expert
Electronics Forum | Tue Oct 13 12:32:43 EDT 2009 | davef
2.6.3 Test Pad Location Tolerances, third bullet. Why does Entek require different test point spacing than other surface finishes? Page 55, top image is off the page, partially. 2.3.6 Depanelization of Arrays, 10th bullet [Breakaway Scoring] refers
Electronics Forum | Tue Mar 13 17:26:07 EST 2001 | blair
1) We could press on BGAs and the boards would boot 2) This is basic boot up yield 3) We are now getting stpe by step inspection data going fwd. 4) So, Stencil design could be a critical factor. Any documented guidelines? 5) Yes DFX was done - mostl
Electronics Forum | Thu Jan 14 15:03:57 EST 1999 | Earl Moon
| I need to buy modestly priced pc layout software for very infrequent use for very simple microwave and analog surface mount multi-layer boards. Can any one recommend a software package which is easy to learn, runs on a Windows PC and interfaces wit
Electronics Forum | Tue Mar 23 07:35:42 EDT 2010 | jooh
Since I'm new to the forum I probably ask previously answered questions (that I have not found) but I would be grateful if someone could clarify this for me. I'm in R&D at a company where we design low volume (1k-10k) fairly complex PCBAs for our pr
Electronics Forum | Tue Jul 14 10:23:42 EDT 1998 | justin medernach
| Hi all, | We are currently having problems with a laser-cut stencil that is | electropolished and nickel plated with 9-mil openings. The paste does | not release well from the apertures. We are having to wipe after every | print. The board is fixtu
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
.gif)
