Used SMT Equipment | General Purpose Test & Measurement
The Agilent 661xC Series System DC Power Supply is an ideal power source for demanding production test applications. This dc power supply offers high performance and precision measurements in a one-box solution. To reduce test-system development time
Used SMT Equipment | Pick and Place/Feeders
Tact time: 0.20sec/chip with line array camera Simultaneous pick with 8 heads 0.45 sec/SO with line array camera Simultaneous pick with 4 heads 1.4 sec/QFP with line array camera Sequential pick with 4 heads 3.7 sec/QFP with area CCD camera In fin
Used SMT Equipment | Soldering - Reflow
Specifications* Model Pyramax 150N Temperature Ratings: Process Chamber 350°C Vacuum Chamber 300°C Convection Heated Zones 10 top and bottom Vacuum chamber Heat Assist 2 heated convection zones Vacuum Chamber Zones 1 Zone Vacuum
Used SMT Equipment | Soldering - Reflow
Electrovert Reflow Oven 1995, 440V in, 42kVA. Five (5) zone top, three (3) zone bottom. Just under ten (10) feet long. The oven is fully operational. However, we have to enter the current BIOS settings every time to start the machine because
Used SMT Equipment | Pick and Place/Feeders
This 1998 Philips Eclipse with LCS is a flexible placement machine. Left to Right. This Eclipse was made for fine pitch placement and smaller components down to 0402. It is versatile and extremely good at a small runs and prototype application. Singl
Used SMT Equipment | Pick and Place/Feeders
2001 Assembleon/Philips/Yamaha Topaz pick and place w/ (20) feeders, LCS for lose and large parts not on Tape and Reel. 44mm bottom side camera, (1) 1m NuTek Staging conveyor (Mfg. of conveyor may vary by time of sale). PM'd right before shut down. M
Used SMT Equipment | In-Circuit Testers
Agilent-Keysight 6612C DC power supply, 0-20 V, 0-2 A, 40 W. GPIB, RS-232 The Agilent 661xC Series System DC Power Supply is an ideal power source for demanding production test applications. This dc power supply offers high performance and prec
Used SMT Equipment | SMT Equipment
Baking SMT on a cheap kitchen toaster oven is not difficult. You just need some patience and exploration good will. In this page you will read the manual procedure to bake SMD boards into a regular kitchen toaster oven appliance. Follows information
Used SMT Equipment | Adhesive Dispensers
Fuji GL541E *Basic Specifications Cycle time 0.09 seconds/dot Travel distance - X-axis within 8mm Y-axis within 6mm Needle up/down distance of 8mm Application time: 0.05 seconds Dispensing accuracy: +/- 0.15mm in th X and Y directions (3 sigma)
Used SMT Equipment | AOI / Automated Optical Inspection
Adjustable Conveyor and Camera Indexing Head Max PCB: 22” x 20” Top-down thin camera with 1.3 FOV Industrialized Pentium with hard drive, RWCD, USB-2I/O Flat Panel Display Cad/placement interface software Windows XP based user
