Electronics Forum | Wed Nov 29 00:26:39 EST 2006 | mack3000
Hello everyone, I've been facing some issues regarding:- 1)missing components 2)overturn 3)misalignments Why does this occur?Is it because of the machines?The programming?Or handling issues? What steps are needed to be taken to counter this problem
Electronics Forum | Wed Jul 02 19:10:45 EDT 2008 | arminski
Hi, Say I'm going to calculate my PPM and DPMO, do I have to include in my defects data an item that the root cause is already identified? example is if I have 4 components with Land Design issues (incorrect dimension) and is causing me insufficient
Electronics Forum | Wed Dec 15 19:31:26 EST 2004 | Thomas Denison
We have a ceramic BGA that the component supplier has misaligned the spheres in the fixture so they slant .007" out of alignment from the substrate pads. When the devices are tested at the component manufacturer this alignment issue also causes the
Electronics Forum | Wed Sep 24 04:18:12 EDT 2008 | gang
we have some problems in soldering joints such as insufficient solder and misalignment on some RC0402 and CC0402,i don't have a pic here. our SMT enginner doubts the PCB land pattern is at the fault.here is what we measured results.pad length:0.9mm,
Electronics Forum | Mon Apr 19 21:37:17 EDT 2021 | ouaret
dear all, update: we got that the calibration of SIM is the problem, the distance between SIMs need to be calibrated. can someone help us get the manual that describe on how to calibrate the SIMs? we have a problem with our cyberoptics AOI machine
Electronics Forum | Tue Aug 28 13:46:46 EDT 2001 | mparker
To clarify on "Opportunities"- With 1000 components, the opportunities are far greater than 1000. You have 1 opportunity per component for a component defect i.e. bent lead, damaged part, tested bad, etc. You have a second opportunity per component
Electronics Forum | Tue Sep 16 19:16:11 EDT 2008 | hegemon
Hello everyone! > > I'm a student of electrical > engineering currently working on a thesis for my > BSc degree. It will be about post reflow AOIs and > AXIs, and I'd kindly like to ask you for some > help with it. > > I would like to know if t
Electronics Forum | Tue Aug 23 03:29:37 EDT 2022 | samhe
I received a buck-boost DCDC board with an optical sensor from NextPCB, so I mounted the components and measured the efficiency. Table of contents Board received from NextPCB Solder paste printing Mounting of parts Reflow operation check Attaching
Electronics Forum | Wed Jul 09 14:47:39 EDT 2014 | deanm
I'm looking for a typical SMT placement defect rate from others in the field so I can judge whether or not we are in an acceptable range. If I give you a board with 200 components (0603, 0805, SOICs, 20mil MSOPs, tantalums, DPAKs and a few 20mil fin