Electronics Forum | Fri Mar 22 10:40:51 EDT 2013 | derekj
Hello all. I was hoping that maybe someone has a manual for a Omniflo 5. Build year is 1998. Photocopies would be greatly appreciated, and willing to pay. Even if we could put down a deposit, you send the manual we do the photocopy and we can send it
Electronics Forum | Wed Feb 09 10:19:19 EST 2005 | pjc
According to one of Electrovert's reflow engineers, hour meters have not been installed "for quite some time". So, I stand corrected, older OmniFlo series ovens may have hour meters.
Electronics Forum | Wed Feb 09 11:37:26 EST 2005 | pjc
Technical support cannot help with this issue, especially Electrovert tech support, those guys only know soldering and cleaning machines. Contact Jim Kaler at Camalot Applications Support: 603-641-8666 ex7208 or jkaler@speedlinetech.com Tech support
Electronics Forum | Sat Dec 16 08:23:11 EST 2006 | pr
The "Wave optimizer" is a little pricey but is easy to use, gives instant feedback (display on the unit as opposed to hooking it up to a computer)and will give feedback on the waves, as well as preheat. They will send you a unit to trial for a week o
Electronics Forum | Thu Aug 20 16:28:11 EDT 2020 | cyber_wolf
My guess is that someone either clamped a board or a ramp at the end while adjusting the width. I have had this issue before. Remove the rails and look down them like a gun sight. I have never had any luck trying to adjust out big bends. If you wan
Electronics Forum | Tue Feb 08 23:29:54 EST 2005 | mrduckmann2000
Help! Does anyone know how to get a Camolot Gem II machine to put down dots for 0402 placement? I have been working with Electrovert Tech's that say their machine WILL place dots for 0402's. I have reduce the speed of the pumps to half the speed,
Electronics Forum | Wed Jul 10 19:17:06 EDT 2013 | m20lara
Hello all. I was hoping that maybe someone has a > manual for a Omniflo 5. Build year is 1998. > Photocopies would be greatly appreciated, and > willing to pay. Even if we could put down a > deposit, you send the manual we do the photocopy > and
Electronics Forum | Thu May 14 10:00:14 EDT 2015 | swag
I like MpM personally - run forever and programming is easy and leads you through it. It's hard to miss a step of programming with MpM software. DEK's a little harder (for me) but still very nice controls. The pluses of DEK - DEK has a high freque
Electronics Forum | Fri May 15 14:50:40 EDT 2015 | emeto
My top 3 printers: 1.DEK 2.MPM 3.EKRA Top 3 ovens: 1. BTU 2. Vitronics 3. Heller or Electrovert
Electronics Forum | Thu Jan 20 14:33:20 EST 2005 | Chunks
Where can I find the "hours run" timer on this oven. Can't locate a physical timer. Is there one located in the software?