Electronics Forum | Wed Jan 27 22:39:46 EST 2010 | wmeliane
Thanks for the recommendations. We have settled on the new Juki CX-1. Juki states that the machine is a hybrid between a MCM placer and an SMT placer. This machine, if it is capable to do what Juki says it can do, is exactly the machine we need. Ma
Electronics Forum | Sat Aug 04 17:46:22 EDT 2001 | Marshall
The YV100X is Phillips TopazX in the U.S. while the YV88 is the Emerald. Now, We find the Juki's 2020 and 2030 more superior than Yamaha's or Philip's because of their flexibility in component handling and the standard features that come with the Juk
Electronics Forum | Fri Aug 17 09:47:02 EDT 2001 | Mike Kennedy
Thank you all for your comments. We ended up going with the Juki machine and are trying to adapt the SMS machine control software. Thank you
Electronics Forum | Fri Jul 27 21:17:10 EDT 2001 | Mike Kennedy
We are looking at another pick&place machine for our production line and are leaning towards the Juki2000 series and the YamahaYV series machines. I would like any feedback from those in the industry who have used either of these machines. Also we cu
Electronics Forum | Wed Nov 21 15:37:46 EST 2007 | afm
We have been looking for an old machine (budget issues), and we have foud Juki 570L and Quad IVc to be around same cost. I have found some comments on the forum for the Quad (good in general), but not too much for the Juki. Beside the expected issues
Electronics Forum | Sun Jan 29 14:10:14 EST 2006 | gipos
Hi GS, We are contract manufacturer for small series of electronic equipment fully trained for SMT.Making mostly RF with only few QFPs,TSOPs...SMT machine assembly was made by local subcontractor when needed. Recently we acquired two Juki 730 machin
Electronics Forum | Thu Aug 02 14:41:01 EDT 2001 | Roger
In the U.S. you cannot buy Yamaha machines. Assembleon (previously Phillips) exclusively markets Yamaha machines in the U.S. and names the machines after rocks. I think the YV100 is sold as either the Topaz or Sapphire by Assembleon.
Electronics Forum | Wed Nov 28 12:29:22 EST 2007 | gregp
Try serarching under Zevatech 570 instead. Or contact me for some alternatives (factory rebuilt machines available). Greg
Electronics Forum | Fri Aug 10 03:58:39 EDT 2001 | welsh
Hello Mike, There is a software availible that can control the machines you have and are looking to buy, It can also perform line balancing, it has also has many other features. check out their website for more information. http://www.timmsweb.com
Electronics Forum | Tue Aug 21 11:18:56 EDT 2001 | roger
Michael, Please keep in mind that this is an SMT Forum, designed to exchange technical information and opinions. While you are free to suggest that a reader investigate a particlar product or service, please save the full-blown advertising for SMT o