Electronics Forum | Thu Oct 27 19:10:36 EDT 2022 | proceng1
My printer handles 1500mm stencil, so no, 4 ft boards print ok. If you are bending the board for the oven, does that mean your printer and PnP handle the full length?
Electronics Forum | Mon Oct 31 14:53:52 EDT 2022 | proceng1
Can you share a photo of this board on a carrier? I'm havinga hard time picturing this?
Electronics Forum | Thu Jun 29 04:50:42 EDT 2023 | SMTA-70263692
This looks like it could be related to oxidation.Do you per-bake your pcb before assembly to remove any moisture inside your board panel?
Electronics Forum | Fri May 26 04:58:19 EDT 2023 | auriga2001
I agree with the two other replies. Left alone, it is a defect. If it's just excess adhesive or coating, you can use IPC-7711/7721 'Rework, Modification and Repair of Electronic Assemblies' for guidance on removing. Section 2.3.1 explains how to te
Electronics Forum | Thu Jul 06 13:36:37 EDT 2006 | SWAG
We've had much trouble with flex circuits. As previously mentioned, you must have local fids for the board or the BGA itself (if panelized). Other troubles we experience are drilled holes for pinned connectors. Unless the PCB manufactur has some w
Electronics Forum | Mon Jun 26 12:23:11 EDT 2006 | Rob
Yep, Book a holiday and let someone else sort it out. Otherwise e-mail me and I'll talk you through pallets, rigidisers, printer tooling, spray mount, Kapton tape, local fiducials (panels can strech & shrink) etc. Oh, yeah - for the connectors you
Electronics Forum | Fri Oct 22 04:09:22 EDT 2004 | christina
Is there anyone who knows the yield rate difference for SMT on multi-flex boards and rig-flex boards ? Basically, I think the yield rate should be higher for rig-flex than multi-flex due to the poor dimensional stability of polyimide, since multi-fle
Electronics Forum | Sun Oct 24 20:55:45 EDT 2004 | christina
Dear Chris Thank you so much for the prompt reply and it really helps. Do you have any SMT experience for rig-flex boards? Can you share with me about the differences with that of rigid boards? Is there any special precaution needed? When you were d
Electronics Forum | Fri Oct 22 11:53:53 EDT 2004 | C Lampron
Hi Christina, What would you be basing the yields off of? Is it solder defect, component placement, etc....? I have worked for a flex house for quite a few years. You are right. The Polyimide is very dimentionally unstable. (even more so on humid da
Electronics Forum | Thu Jun 26 09:04:43 EDT 2003 | caldon
We had a "Spring loaded" fixture that pulled the Flex tight and used loads of Board supports. There were pins that went through the Connectors holes and held the flex firm. We only had a few components so it was no problem. Lucky for us because the f