Electronics Forum | Thu May 08 11:33:23 EDT 2008 | rkeck
I am looking for information mainly for installation instructions for the Infra Flow 5 oven. Anyone that has experience with this oven as far as exhaust requirements or has a manual they could access, please contact me.
Electronics Forum | Wed Oct 22 14:55:00 EDT 2014 | rrosera
Does anyone have any experience with labels capable for withstanding both re-flow and machine wash cycle? We've tried a few different materials and the ones that make it threw re-flow wash off and the ones that make it threw was tend to melt in re-fl
Electronics Forum | Wed Aug 02 04:48:17 EDT 2017 | korak666
Hello, i want to create a production flow chart in Aegis NPI can someone direct me or send me a good flow chart he is working with. Thank you
Electronics Forum | Tue Feb 09 21:00:32 EST 2021 | dekhead
Unfortunately, with the Micron ('i') series of machines, DEK seemed to stop making "ProFlow Ready" the standard on machines. In general, there are additional pneumatics and electronics required for a ProFlow installation.
Electronics Forum | Wed Mar 10 15:09:34 EST 2004 | Jay
You can say "re-flow". It's related with the process. In order to assemble a PC Board containing lots of components such as PTH (Plated Through Hole) and SMT, usually, PTH type packages and components are soldered first using wave soldering process.
Electronics Forum | Wed Oct 21 01:46:57 EDT 1998 | Daniel
We currently using the Panasert SMT machine where PCB flow direction were from right to left, & we are planning to move in the FUJI -CP3 & CP4-2 in line where standard PCB flow direction were left to right. Any comment on FUJI machine modification of
Electronics Forum | Wed Oct 21 09:24:55 EDT 1998 | Paul Walz
| We currently using the Panasert SMT machine where PCB flow | direction were from right to left, & we are planning to move | in the FUJI -CP3 & CP4-2 in line where standard PCB | flow direction were left to right. | Any comment on FUJI machine modif
Electronics Forum | Tue Jul 27 15:15:48 EDT 2004 | JSTARKEY
We have recently encountered a problem that we haven't seen before: The solder joint appears to be wetting ok and the solder is re-flowing but the appearance of the solder after re-flow is pitted. Using Kester 531, humidity around 41% temperature aro
Electronics Forum | Wed Jan 16 10:52:19 EST 2008 | kbhatia
R SMT line flow to a R->L flow after the 90 degree turn. We have some equipment that is R->L and wish to interface to the end of this line. So the flow is oven (with enough air blowers that the 8040 is cool) -> 8040 turnstyle to move LEFT (technicall
Electronics Forum | Fri Feb 15 11:58:55 EST 2008 | rkeck
We are looking at an Omni Flow 5 Oven and do not have much information on it. We do know it has a 3" cabinet vent and a 6" vent near the center on the top. If anyone has knowledge of this oven, and has any suggestions or info, we would appreciate