Electronics Forum | Tue Feb 24 15:32:10 EST 2015 | swiese242
Hi there. I have an IP3 machine that refuses to > power up the MFU cart on side 1. I have already > replaced the I/O card but still no dice. Is > there a relay or fuse that I need to check to get > this to power up? The machine will not operate
Electronics Forum | Mon Jul 17 20:50:42 EDT 2017 | davef
For service related problem, contact Dave Byker at 847-913-0162
Electronics Forum | Thu Apr 12 15:21:12 EDT 2012 | jdengler
Have you tried to do a reset start? When Fuji's act weird the first place to start is a reset start, then re-load the Proper Status and Program. Jerry
Electronics Forum | Thu Apr 12 17:49:35 EDT 2012 | rodrigo
I've done the Fuji flush. It does the same thing. We can not load proper again because it does not communicate with either the F4G or MCS/30. I was able to boot into mechanical mode at one point but now I can not do that either. This thing is drivi
Electronics Forum | Wed Apr 22 12:50:39 EDT 2020 | rodrigo
Hi all, One of our Fuji CP-642 machines has a weird problem. It does not happen every time but often enough that it is a problem. I power up and press start to zero it. The problem is the zero...ing does not finish. It moves the xy-table, D1/D2 table
Electronics Forum | Wed Jul 12 17:05:22 EDT 2017 | rodrigo
Hi all, Our Fuji cp6 woke up with a bad power supply (ps) this morning. The ps is one of two 24vdc (Corsel P300E-24). There is one inside the cabinet and one on the door where the cpu card is. The bad one is the one inside the cabinet. So we had anot
Electronics Forum | Tue Jan 22 17:29:34 EST 2008 | fastek
Not quite correct Jon. Ovens will use roughly 1/2 their rated power consumption at temp. but will draw their rated max. power at startup.
Electronics Forum | Tue Jan 22 16:01:03 EST 2008 | jmelson
The P&P machine uses very modest power when idling. It draws burst of power when accelerating the gantry. So, the yearly power consumption is going to be a LOT less than nameplate figures. If it is largely air-driven, then you have to factor in th
Electronics Forum | Thu Apr 24 12:45:41 EDT 2003 | cyber_wolf
Can someone possibly post a link, or get me the specs/requirements of an Omniflow 10 reflow oven ? Air consumption, power consumption, dimensions etc... Thanks
Electronics Forum | Mon Jun 27 03:40:44 EDT 2011 | samsim
Other areas you can focus 1) Find out alternative chemical and solder materials for lower cost. 2) Set high power consumption machine (such as Oven and wave) to idle mode when not running to cut electrical consumption. 3) Reduce the used of N2 gas.