Electronics Forum | Fri Jan 14 09:36:49 EST 2000 | Richard
If the gold fingers are pad types which plug into expansion slot connectors, I have used a titanium guard attached to the wave conveyor over the solder pot, which allows the PCB to connect to the fingers but masks the solder from the gold pads along
Electronics Forum | Thu Jan 13 12:07:24 EST 2000 | Tony Nirchi
Gold finger connector over a wave solder, what would be the best way to protect the fingers from solder.This is a high volume job.
Electronics Forum | Fri Jan 14 15:02:16 EST 2000 | John Thorup
Second the motion for the Stevens Products covers. They call them Gold Fingers Gloves and they are a pull-truded fibreglass product that comes in sticks. You hacksaw them to the length needed. We have many that have been through the wave thousands o
Electronics Forum | Tue Oct 26 12:18:53 EDT 1999 | Gary Kemp
We are having a discolorization problem with the gold fingers on our PCB's. I have been made aware that there is a gold touch-up paint (masking) that is available. Would anyone know where I can get my hands on some of it? Any help would be appreci
Electronics Forum | Fri Nov 13 06:21:21 EST 1998 | Chuck Garth
I believe that gold fingers on my circuit boards are being contaminated and need to clean them with some chemical solution. Any recommendations.
Electronics Forum | Fri Nov 13 15:55:48 EST 1998 | Dave F
| I believe that gold fingers on my circuit boards are being | contaminated and need to clean them with some chemical | solution. Any recommendations. | Chuck: What is the type and source of your contamination? Dave F
Electronics Forum | Thu Jul 03 11:36:57 EDT 2003 | Ron
Have you considered a temporary water washable solder mask. Elvaway solder mask tapes have been protecting Gold Fingers during soldering and simply wash away in a water wash process and leaves no residue.
Electronics Forum | Thu Jul 20 02:42:34 EDT 2006 | Francis
Short term, taped the gold finger. long term, study the air flow of the reflow section of the oven. It is always being overlook at this part and lookout for the printer. The air flow must be laminar and properly flowed back.