Electronics Forum | Wed Sep 27 17:06:26 EDT 2006 | daxman
Hey Guys, I checked the histogram...it doesn't look good. I'm assuming the graph for the black bars has to be in the green on the left and the graph for the white card needs to be in the green on the right?? Anyways, I can't find a "GS4 pot" I looke
Electronics Forum | Fri Jun 09 11:11:24 EDT 2000 | po
If you spent alittle more time on your bar graphs/time lines and less on the floor, the answer would be obvious!
Electronics Forum | Sat May 27 09:51:09 EDT 2000 | Bob Willis
If you want a procedure and a spread sheet graph for calculating defect data its free to download on my web site www.bobwillis.co.uk
Electronics Forum | Tue Jan 08 17:47:15 EST 2002 | mantis
Well assuming that the parts are genuinely damaged when rejected and you want to rework them to reduce scrap,you could use a shadow graph and get the mechanical spec on clear film.Then rework accordingly you should be able to rework most leads.
Electronics Forum | Wed Dec 04 18:59:34 EST 2002 | Steve Godber
Is there a Technical graph/chart/table guideline for designers on which Solder Sphere/pad size is plotted vs. pitch design to acheive maximum SJR?
Electronics Forum | Tue Jan 14 16:26:41 EST 2003 | Dave F
Let me make it simple than! one controller should be enough for a 400 sq ft room as a good rule of thumb. Although there are many factors that can affect this rule of thumb so read your graphs and take the approciate action. Dave
Electronics Forum | Wed Jul 06 20:40:40 EDT 2005 | davef
Voltage does not flow. Current flows as a result of a change in voltage. Current capacity of traces * Graph is IPC-2221 paragraph 6.2, Figure 6.4 * http://www.geocities.com/CapeCanaveral/Lab/9643/TraceWidth.htm
Electronics Forum | Thu Nov 03 07:22:16 EST 2005 | davef
arnold: I did not say that Sn100 dissolved copper faster. The graph of dissolution rates [from the link above] shows that Sn100 dissolves copper slower than many of the other solders.
Electronics Forum | Fri Dec 01 11:36:53 EST 2006 | Rob
These are usually 260C for 5 seconds, however, this is only the top end of the graph. Ask your supplier for the recommended profile for this part and check that you are inside the curve for the whole process. We are going through around 250K of the
Electronics Forum | Fri Apr 27 22:16:16 EDT 2007 | the silicon horizon
www.thesiliconhorizon.com turn your toaster oven into a SMD reflow oven! this controller can be standalone with LCD and keypad, or through USB with our free software! change pid gains, profiles, program to controller, print graphs and much much mo