Electronics Forum | Wed Jul 22 05:54:41 EDT 2015 | langkeauto2015
Hi, Tsvetan, sorry for your bad experience for Chinese brand PNP machine. For your doubt, pls refer to my comment:) Our pnp machine is special for led tube, led panel, led strip, RGB strip, and led display screen PCB, and real working speed feedbacke
Electronics Forum | Wed Jul 22 07:20:12 EDT 2015 | spoiltforchoice
I'm not entirely sure that is accurate. The only people who want small 'desktop' machines are hobbyists/labs who are unable to accept the costs and time constraints placed upon them by a subcontractor and think they can do better themselves. Standalo
Electronics Forum | Wed Jul 22 10:04:59 EDT 2015 | langkeauto2015
thanks for your keen analysis, totally agree with you. If we want to explore foreign market, find one reliable agent is necessary who is professional for led smt machines as you said, after all, the cost to establish branch office is higher , and eve
Electronics Forum | Mon Mar 11 07:05:06 EDT 2024 | klauss
while conveyor goes down to relaese pcb, some big compoments are swinging left or right due to high down speed of the conveyor. is there any way to decrease the speed?
Electronics Forum | Thu Dec 22 07:43:35 EST 2005 | grantp
Hi, That's true, and the plant just does not look high tech without that PC on the front of the wave. I should donate the wasted processor cycles to the SETI screen saver if it's still going on. Regards, Grant
Electronics Forum | Tue Dec 13 12:56:17 EST 2005 | grantp
Hi, We have a problem sometimes where our soltec oven will accept another PCB too soon after it's taken the last one, so the PCB will collide with the last PCB that just enter the oven, and knock half the components off one of the boards, and destro
Electronics Forum | Wed Dec 13 01:14:02 EST 2017 | tsvetan
"Pros: -You can fit more feeders on your machines. -One dual lane feeder is cheaper than two single lane feeders" none of these is true for Sony SI-G200 machines we have dual lane feeders are bigger than the standard 8 mm feeders so no space savin
Electronics Forum | Tue Jun 17 07:17:09 EDT 2003 | James
The main problem I am having is getting the Rising slope 1-3 degrees. If I slow the conveyor down then I have too long of a reflow and if I speed it up then my ramp rate is too high. I was not sure if I need my first zones at a low temp or higher t
Electronics Forum | Tue Dec 12 17:34:39 EST 2017 | spoiltforchoice
A pattern emerges, but really I think it means plan/optimise for your day/week not a single job. Our machine uses 10's, this means there's a significant chunk of the feeder that is not easily accessible if something like a brass shim gets stuck or f
Electronics Forum | Wed Aug 20 08:05:06 EDT 2008 | pjc
They are faster today, but still not up to fixed-pin machine speeds. They tend to be 7x to 10x slower. Any of the machine suppliers can run a test evaluation and give you a report on test coverage and test times. There are techniques to make them fas
.gif)
