Electronics Forum | Mon Aug 27 10:23:41 EDT 2012 | cobham1
I need to clarify something for everyone. The end customer is the Military. Our customers are military suppliers who do in fact have quality systems in place. When we build the product we end up potting the unit so the customer never looks at the ele
Electronics Forum | Fri Aug 24 10:20:59 EDT 2012 | rway
We use CCI as well, but you might check out Q1 Test Fixtures in Ontario, CA. Their fixtures are a bit cheaper than CCI and the quality is just as good. Contact Tim Richmond: 952-454-4474
Electronics Forum | Mon Aug 27 08:58:24 EDT 2012 | rway
Reese, > > We would agree about the value of an > ICT system, in a general manufacturing > environment. However, a couple of notes > apply: > > 1. ICT isn't a catch-all, either, and > should be used to verify the process, not > validate it.
Electronics Forum | Mon Aug 27 09:23:22 EDT 2012 | rway
Which military? The US? Being a military contractor, I am surprised at your lack of quality at your facility. I suspect this is non-US military. I don't know where you are located, but being a contract mfg for the military, any military, I can im
Electronics Forum | Mon Aug 27 09:14:51 EDT 2012 | rgduval
We've seen a number of 0603 parts not being marked, more and more often in the market. Unfortunately, we never narrowed it down to whether or not it was manufacturer related, or separate product lines within a single manufacturer that were available
Electronics Forum | Mon Aug 27 08:52:57 EDT 2012 | rgduval
Reese, We would agree about the value of an ICT system, in a general manufacturing environment. However, a couple of notes apply: 1. ICT isn't a catch-all, either, and should be used to verify the process, not validate it. Quality should be buil
Electronics Forum | Tue Jul 08 06:00:29 EDT 2003 | iman
As part of our process/quality improvement review, it was raised thru' our findings that its a good mfg practice to monitor the incoming solder paste quality (as part of the indirect materials). We get one-page "outgoing QC" vendor reports with each
Electronics Forum | Thu Dec 17 17:34:26 EST 1998 | Earl Moon
| Has any anyone established / published quality standards for BGA solder joints? Is IPC-A-610 in process of adding standards for BGAs? | The debate continues. I have felt for some time a maximum 20% voiding is allowable under certain conditions (w
Electronics Forum | Wed Jun 06 20:45:54 EDT 2001 | Deon Nungaray
.020" The logic behind this is that from the time of the initial fiducial check, to the time of the critical parts placement which are typically placed last, there may be changes. What I mean by changes is that depending on what type of assembly equi
Electronics Forum | Wed Oct 11 05:58:13 EDT 2023 | kojotssss
Hello all, I know there are very skilled guys. Can anyone suggest a stencil design to avoid component displacement during reflow to improve tension of surface forces and selfalignment? There are cases where the inductors are shifted. All parameters