Electronics Forum | Tue Sep 04 14:02:35 EDT 2018 | elsabudz
Hi Peter, I read your concerns regarding IC parts not packaged with desiccants and thought you may find our new Type 2 Humidity Indicator card of interest. Please visit https://www.clariant.com/type-2-humidity-indicator-card Thanks, Elsa
Electronics Forum | Tue Apr 15 21:24:41 EDT 2008 | davef
We find it curious that: * Heat slug pad for Q19 didn't take solder, indicating a pad [board] solderability issue. * Signal termination pads for Q19 didn't flow well, indicating a poor thermal recipe or a pad [board] solderability issue. * Signal ter
Electronics Forum | Wed May 07 20:55:35 EDT 2003 | davef
Bollocks!!!! We are unfamiliar with the term overturn, but it can not be that uncommon. Our intial inclination is to barrel into this SMT Engineer's nap-zone and blast him, but it might not be a politic approach. So, maybe we'll temper the tack we
Electronics Forum | Fri Aug 06 11:07:49 EDT 2004 | JB
"I thought it was purely a mechanical up-down movement with the cam and hence the thickness hardly has any effect!" It is purely mechanical.On our high speed turret the machine knows the distance between the tip of the nozzle and the top surface of
Electronics Forum | Fri Apr 08 05:22:47 EDT 2005 | Bored
The light events are: Red - Alarm - Indicates that an alarm exists.This also occurs when the emergency power stop button has been used to stop the belt and turn off heater power. Orange - Alert - Indicates that an alert condition exists. Green - R
Electronics Forum | Thu Mar 20 07:58:12 EDT 2008 | cyber_wolf
#1Run a Fuji gold board and see if the problem persist. Is your board clamp slipping? Fid camera tight? etc.. To see if you have a Y axis positioning problem: 1.Put the machine in mecha check 2.Go into Y-axis 3.Place a dial indicator so that the st
Electronics Forum | Tue Jan 13 08:08:37 EST 2009 | leemeyer
I am assuming that the card that was changed was the motor driver card. Did they change the card with a known good board or just swap the X and Y cards. If they swapped cards it appears that the card that is now in the X motor slot is bad. Open the a
Electronics Forum | Mon Aug 31 19:15:36 EDT 2020 | dilogic
We have GSM2 with FlexJet heads (an older one). There are 7 sensor amplifiers (with LED indicators) for touchdown detection and one for z-safe detection which is of a different type (with numeric LED indicator). I can't find anywhere what the right n
Electronics Forum | Thu Mar 14 15:55:34 EDT 2024 | davef
Process Requirement Standard - J-STD-001 - Requirements for soldered electrical and electronic assemblies depicting minimum end product acceptable characteristics as well as methods for evaluation (test methods), frequency of testing and applicable a
Electronics Forum | Mon Apr 08 15:47:07 EDT 2024 | kingkelvin
Hi all - all good info thanks, so my indicator levels are a bit off which I knew - but I didn't realize that might be the source of this problem - after speaking with PFI and realizing the next step is to get the indicator levels to the 190 range (ma