Electronics Forum | Tue May 18 16:40:22 EDT 2010 | m79d
I am having some problems getting the IP1 to place a SSOP28 package,pitch 0.65mm lead width 0.3mm. I am selecting computer vision 012 (tried 011) and vision type 100. EL data was put in looking at the datasheet and also measuring the device. Have tri
Electronics Forum | Tue May 18 21:43:02 EDT 2010 | ashley
Hello mickd, 1) The EL data & Vision_type is NOT necessary when using MCS30 for IP1 machine. note : your input of the above might have cause confusion during VP, hence the OS error. 2) I would suggest the following... 2a) lower the Lead_check_are
Electronics Forum | Fri Apr 13 10:57:50 EDT 2007 | bigguy
hi we have an Essemtec FLX 2010 L that has a large board capacity of 600x700mm(23.6x27.5")
Electronics Forum | Sat Apr 14 10:21:30 EDT 2007 | HOSS
We are processing a 5x22" PCB using Juki "2010E and 2060E". Machines are spec'd as 18x20" cabable. We just needed to adjust a conveyor sensor (1 time) and ignore a few placement area warnings.
Electronics Forum | Wed Mar 24 12:54:02 EDT 2010 | davef
Ignore the defect * Late 1990s to early 2000s => ICT * Early 2000s to mid-2000s => MDA * Mid-2000 on-ward => AOI
Electronics Forum | Wed Mar 31 04:43:52 EDT 2010 | accuspares
If you dissconnect the crash beam sensor one at a time at the front leaving the remaining one connected you’ll be able to identify what side is causing the problem. Then you will be able to hopefully remove the object or adjust the position of the be
Electronics Forum | Tue Apr 20 11:25:59 EDT 2010 | cunningham
Has anyone got any of these ovens or know of any issues with these? We are on the market for a 10 or 12 zone oven and the BTU above is looking like the favourite Any info would be great
Electronics Forum | Tue Mar 30 02:19:17 EDT 2010 | jooh
Regarding X-ray I was referring to ssager's comment "...X-Ray is only as good as the human eye that is operating it...". I thought x-ray images could be checked by software algorithms to find defects, not only human eye?
Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Fri Oct 29 23:08:06 EDT 2010 | laen
What software are people using to compute route and retain tabs on panels? I produce some complicated (150 board, 80+ different design) panels, and I haven't found a good way to programmatically compute where to place the tabs. Thanks.