Electronics Forum | Tue Nov 28 09:37:39 EST 2006 | GS
Have you seen IPC-A-610 D ? regards GS
Electronics Forum | Fri Nov 03 07:28:27 EST 2006 | davef
Via filling methods are: * Tenting * Plugging * Capping * Flooding Tented Via. A via covered with dry film soldermask; the via is not filled. When tenting from both sides there may be issues with trapped air that expands during mass soldering. Plug
Electronics Forum | Mon Apr 25 11:24:31 EDT 2005 | Daan Terstegge
I have a question about inspection, touch-up, and how far you need to go to get a product that meets the required IPC-spec. According to some reports (i.e. "New Study Reveals Component Defect Levels" by Stig Oresjo of Agilent) the average defect leve
Electronics Forum | Wed Nov 03 09:42:31 EST 2004 | dramos1
Hi Simon, Thanks for the immediate reply. We really appreciate it very much. Currently, we are using Class 2 for the visual inspection criteria of our telecom boards. In IPC-A-610 Rev. C criteria, there are TARGET, ACCEPTABLE and REJECT criterias.
Electronics Forum | Thu May 23 13:24:14 EDT 2013 | rgduval
We agree that it looks like a touch-up process. However, we're not certain that it would meet Class 3 requirements. It appears to be an incomplete solder joint. The outer bit of solder shows voiding to the inside bit of the solder joint, and it lo
Electronics Forum | Fri Aug 23 18:51:00 EDT 2002 | edahi
weve done a few evaluations for the no-flow underfill and for the reliability I think it has already passed MRT L3 @ 220C reflow. What is it specifically you're interested about the flow u/fill??
Electronics Forum | Fri Oct 17 16:31:53 EDT 2014 | dyoungquist
Per IPC-A-610D: Target is 100% vertical fill but 75% vertical fill is acceptable for Class 1,2,3. Only needing 75% fill of the barrel when soldering plate through on an 0.093" thick board with our selective solder has been a life saver at times.
Electronics Forum | Wed Sep 18 14:12:40 EDT 2013 | pjchonis
Hello Bachman. SAC305 is the most common lead-free solder alloy, not only for wave soldering but also selective. Most of our selective customers (especially automotive) are using SAC305. What is more important than the alloy to consider is the flux
Electronics Forum | Tue Aug 21 08:34:03 EDT 2007 | rgduval
We have the same problems with cut/tape parts. But, we specialize in short-run prototypes, so I don't have much of a choice but to deal with it, and find a way to make it as easy as possible. We just demo'd a splice tool from Sierra Electronics (ww
Electronics Forum | Wed Nov 03 14:46:29 EST 2004 | dramos1
Hi Russ, Thanks for the reply. In IPC-A-610 Rev. C on section 5.2.9 {Mounting - Connectors] page 5-21 on the manual [January 2000], the acceptable class [1,2,3]listed 3 items. In order for the connector to be accepted, are all 3 items must be met? I
.gif)
