Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Thu Jun 30 18:28:47 EDT 2005 | KEN
1. Migrate to horse-shoe pad design. 2. Verify your furnace is level. 3. Verify your chains are not jerking around. 4. Speed control for fans / gas amplifiers are correct or normal? 5. (this happended to me once) Make sure you don't have any f
Electronics Forum | Wed Jan 18 09:55:09 EST 2006 | chunks
Samir brings up a good point with convection ovens. The flow rate of the fans can move parts, which can cause tombstoning to very light/small components. Also, check you conveyor and or chain. If it is not running smoothly, even a slight shake o
Electronics Forum | Wed Jan 18 16:16:37 EST 2006 | Darnell
Samir brings up uh pimp-tight point wiff convection ovens. The flow rate o' da fans can move parts, which can cause tombstoning ta very light/small components. Also, check ya conveyor an' or chain. If it iz not running smoothly, even uh slight shak
Electronics Forum | Wed Apr 25 05:52:23 EDT 2007 | pavel_murtishev
Good afternoon, The only one intelligent feeder disadvantage is higher price. Pros are: - Feeds components smoothly without jerks; - Adjustable pitch, no need to adjust feeder mechanic to change pitch, selects pitch automatically according to place
Electronics Forum | Thu Apr 12 17:49:35 EDT 2012 | rodrigo
I've done the Fuji flush. It does the same thing. We can not load proper again because it does not communicate with either the F4G or MCS/30. I was able to boot into mechanical mode at one point but now I can not do that either. This thing is drivi
Electronics Forum | Tue Dec 28 15:35:21 EST 1999 | Mike Naddra
Edmund, An 0603 component should not fall from the board durring an inverted reflow pass, provided that: Your land geometries are correct for the package type (Start with SM 782 guidlines)- as surface tension of the liquidous solder is what holds
Electronics Forum | Fri Aug 02 11:38:14 EDT 2002 | Mike Konrad
Hi CarlN, I�m quite surprised that you viewed my response to your question as a �canned response�. I discussed transducer wattage, transducer amplitude, chemical selection (more than just ours) in an effort to assist your in adhesive removal issue.
Electronics Forum | Mon Feb 02 16:30:46 EST 2004 | paul_bmc
I have one machine that I am having trouble getting the machine to recognize an offset. I keep getting the error, "When correcting Offset 1: Invalid offset, press 'esc". Does anyone know what I am doing wrong. On another machine I have I keep havi
Electronics Forum | Tue Aug 01 12:16:10 EDT 2006 | Vernon
Had a similar problem on a high speed drilling machine. It took 1 month before I found it. In the leadscrew ball nut, there was a guide tube which the balls circulate through. at the end of the tube is a shaped lip. This lip was damaged and the balls